Jump to a service
Hurst, TX
Garage door spring replacement in Hurst, Texas
A broken torsion spring is the most common reason a door stops lifting. The fix is a matched pair sized to what the door actually weighs, not the cheapest spring that fits the shaft.
A torsion spring stores enough energy to cause serious injury. It should only be unwound, adjusted or replaced with proper winding bars by someone trained to use them. This is not a do it yourself repair at any skill level.
Springs in Hurst
A one piece tilt up door swings out as it opens and carries its springs on the jamb, so it behaves nothing like the sectional door most people picture. Steel got thinner as the decades passed. A single layer door pressed in the 1970s uses a heavier gauge than a current builder panel of the same size, and it weighs accordingly. Sizing a spring from a chart keyed to door width and height can therefore come out light on an older door. Two doors of identical size from different decades are not the same load. An 8 foot single door often runs one torsion spring where a 16 foot door runs a pair. That single spring has no partner to share the load, so the door drops hard when it breaks and the opener cannot lift it at all. Some single doors of this width still use extension springs stretched along the horizontal tracks instead. Usually under two hours from arrival.
What that means for a Hurst door
A wood door that is still original has not weighed the same all its life. Timber takes on moisture in a damp garage and gives it back in dry months, and layers of paint add to the section over the years. The spring was wound for the door as it left the shop. The same door can sit differently in a wet season than in a dry one. One piece tilt up doors do not use a torsion shaft above the opening. The springs mount on the jambs and work with the pivot arms, so the balance point changes as the slab swings out. Hardware for jamb mounted spring systems is not interchangeable with sectional torsion parts, and the geometry of the arm matters as much as the spring rating.
Signs you are dealing with this
- A visible gap in the coil of the spring above the door
- The door is far too heavy to lift by hand
What we check on arrival
- Whether the existing springs were correctly specified for the door weight
- Cable and drum condition, since a broken spring often damages both
$200 to $450
A standard pair of torsion springs on a two-car door sits mid-range. Oversized, high-cycle or custom-weight doors run higher.
This is a range, not a quote. The exact price comes after we see the door and you approve it before any work starts. Call (469) 281-7750 and describe what it is doing.
Hurst at a glance
- County
- Tarrant County
- Drive from our Coppell base
- About 30 minutes from our Coppell base
- Postcodes covered
- 76053, 76054
- Around
- North East Mall, Chisholm Park, Hurst Community Park
Before we get there
A torsion spring stores enough energy to cause serious injury. It should only be unwound, adjusted or replaced with proper winding bars by someone trained to use them. This is not a do it yourself repair at any skill level.
About Hurst
One piece tilt up doors and their jamb mounted spring hardware still exist in older Hurst neighbourhoods.
Tarrant County. About 30 minutes from our Coppell base.
What that means for a door here
A one piece tilt up door swings out as it opens and carries its springs on the jamb, so it behaves nothing like the sectional door most people picture.
We work throughout Hurst, including the neighbourhoods around North East Mall, Chisholm Park, Hurst Community Park.
Get a price
Tell us about your Hurst door
If the door is stuck open or will not close, call. That is a security problem and the phone is faster than anything else on this page. We are about 30 minutes away, and Hurst sits in Tarrant County.
A person answers 7am to 11pm.
Questions
Springs in Hurst, asked and answered
Do you cover Hurst?
Yes. Hurst is in Tarrant County, and it is one of the 32 cities covered from the Coppell base. About 30 minutes from our Coppell base. That covers postcodes 76053, 76054.
What usually fails on a Hurst door?
Torsion springs fail by fatigue at the surface of the wire, so anything that pits that surface shortens the cycle life. Rust from an unheated garage does exactly that. A light coat of oil wiped along the coils slows corrosion and cuts the friction between coils as they wind, which is also what quiets the groan some doors make on the first few feet of lift.
How long does garage door spring replacement take in Hurst?
Usually under two hours from arrival. Single layer steel doors sit at the light end of the residential weight range, so their springs store less energy than an insulated door of the same width. The correct replacement is still read off the old spring: wire diameter, inside diameter, length, and wind direction. Door width alone does not determine the spring, because panel construction changes the weight it has to balance.
Is the work guaranteed?
Parts and labour carry a 5 year warranty. The price is agreed before any work starts, and the on site estimate is free.
Is there anything specific about garage doors in Hurst?
One piece tilt up doors and their jamb mounted spring hardware still exist in older Hurst neighbourhoods. Steel loses a little toughness as it gets cold and the grease on the coils thickens, so a spring already near the end of its cycle life often lets go on the first hard freeze of the season rather than on a mild afternoon. The cold does not wear the spring out. It finishes off one that was already close.
Get it fixed
Get a springs price for your Hurst door
Tell us what it is doing. The estimate on site is free.