Jump to a service
Euless, TX
Garage door spring replacement in Euless, Texas
A broken torsion spring is the most common reason a door stops lifting. The fix is a matched pair sized to what the door actually weighs, not the cheapest spring that fits the shaft.
A torsion spring stores enough energy to cause serious injury. It should only be unwound, adjusted or replaced with proper winding bars by someone trained to use them. This is not a do it yourself repair at any skill level.
Springs in Euless
Euless sits directly under the DFW approach path, and a single layer uninsulated door stops neither the August heat nor the aircraft noise. Steel got thinner as the decades passed. A single layer door pressed in the 1970s uses a heavier gauge than a current builder panel of the same size, and it weighs accordingly. Sizing a spring from a chart keyed to door width and height can therefore come out light on an older door. Two doors of identical size from different decades are not the same load. Steel loses a little toughness as it gets cold and the grease on the coils thickens, so a spring already near the end of its cycle life often lets go on the first hard freeze of the season rather than on a mild afternoon. The cold does not wear the spring out. It finishes off one that was already close. Usually under two hours from arrival.
What that means for a Euless door
The red release cord drops the door off the opener trolley so it can be worked by hand. With a broken spring, that hand is holding the whole door, and a double door in that state is beyond what one person should lift. A door already up when the spring fails should be left up and blocked rather than pulled down. Leftover parts on the horizontal track tell whether a door was converted from extension springs to torsion. Pulley brackets and an empty rear hanger near the back of the track are what stays behind. A conversion brings a shaft, end bearing plates, drums and cables with it, so the hardware above the opening is often newer than the door below it.
Signs you are dealing with this
- A loud bang from the garage, then the door will not open
- A visible gap in the coil of the spring above the door
What we check on arrival
- Center bearing plate and end bearing wear
- Door balance after installation, tested by hand at three heights
$200 to $450
A standard pair of torsion springs on a two-car door sits mid-range. Oversized, high-cycle or custom-weight doors run higher.
This is a range, not a quote. The exact price comes after we see the door and you approve it before any work starts. Call (469) 281-7750 and describe what it is doing.
Euless at a glance
- County
- Tarrant County
- Drive from our Coppell base
- About 25 minutes from our Coppell base
- Postcodes covered
- 76039, 76040
- Around
- Texas Star Golf Course, Bob Eden Park, Midway Park
Before we get there
A torsion spring stores enough energy to cause serious injury. It should only be unwound, adjusted or replaced with proper winding bars by someone trained to use them. This is not a do it yourself repair at any skill level.
About Euless
A large share of Euless housing dates to the 1970s and 1980s, with single layer uninsulated steel doors still in place.
Tarrant County. About 25 minutes from our Coppell base.
What that means for a door here
Euless sits directly under the DFW approach path, and a single layer uninsulated door stops neither the August heat nor the aircraft noise.
We work throughout Euless, including the neighbourhoods around Texas Star Golf Course, Bob Eden Park, Midway Park.
Get a price
Tell us about your Euless door
If the door is stuck open or will not close, call. That is a security problem and the phone is faster than anything else on this page. We are about 25 minutes away, and Euless sits in Tarrant County.
A person answers 7am to 11pm.
Questions
Springs in Euless, asked and answered
Do you cover Euless?
Yes. Euless is in Tarrant County, and it is one of the 32 cities covered from the Coppell base. About 25 minutes from our Coppell base. That covers postcodes 76039, 76040.
What usually fails on a Euless door?
Spring life is counted in cycles rather than years, where one cycle is a full open and close. A house that uses the garage as its main entrance can run eight cycles a day, which works through a 10,000 cycle spring in three to four years. The same spring on a door opened twice a day lasts well over a decade.
How long does garage door spring replacement take in Euless?
Usually under two hours from arrival. A garage built in the 1980s has often been through at least one door since. The springs above the opening answer to whatever hangs there now, not to the year the house went up. A replacement door of the same width can weigh more than the original, and a door swap does not always come with a spring change.
Is the work guaranteed?
Parts and labour carry a 5 year warranty. The price is agreed before any work starts, and the on site estimate is free.
Is there anything specific about garage doors in Euless?
A large share of Euless housing dates to the 1970s and 1980s, with single layer uninsulated steel doors still in place. The stationary cones of a torsion assembly bolt to a spring anchor bracket fastened into the header above the opening. On a 16 foot door that bracket resists the torque of both springs. Lag screws pulling out of a split or shimmed header let the bracket shift, which shows up as the shaft climbing away from the wall when the door is closed.
Get it fixed
Get a springs price for your Euless door
Tell us what it is doing. The estimate on site is free.