Jump to a service
Colleyville, TX
Garage door spring replacement in Colleyville, Texas
A broken torsion spring is the most common reason a door stops lifting. The fix is a matched pair sized to what the door actually weighs, not the cheapest spring that fits the shaft.
A torsion spring stores enough energy to cause serious injury. It should only be unwound, adjusted or replaced with proper winding bars by someone trained to use them. This is not a do it yourself repair at any skill level.
Springs in Colleyville
A side entry garage puts the door in view from the street at an angle, so in Colleyville a panel that almost matches is a visible problem rather than a hidden one. Some doors of that period carry an enclosed counterbalance, with the torsion spring running inside a steel tube above the opening and wound through a fitting at one end rather than with bars. A spring that fails inside the tube leaves nothing visible from the floor. The first sign is a door the opener can no longer lift. Doors built from the 2000s onward usually carry a manufacturer label inside an end stile or on the back of a section, listing model and serial. That label is the shortest route back to the original hardware specification, including the counterbalance the door left the factory with. Paint on the outside face does not touch it. Usually under two hours from arrival.
What that means for a Colleyville door
Torsion springs are handed. A left wound spring and a right wound spring are not interchangeable, and the winding cones are commonly colored to show which is which, red for left wound and black for right wound. On a two spring shaft one of each is fitted, mounted either side of the center bracket, so a matched pair means matched in hand as well as in size. Steel loses a little toughness as it gets cold and the grease on the coils thickens, so a spring already near the end of its cycle life often lets go on the first hard freeze of the season rather than on a mild afternoon. The cold does not wear the spring out. It finishes off one that was already close.
Signs you are dealing with this
- The opener strains, hums, or lifts the door a few inches and quits
- The door slams down rather than lowering under control
What we check on arrival
- Cable and drum condition, since a broken spring often damages both
- Center bearing plate and end bearing wear
$200 to $450
A standard pair of torsion springs on a two-car door sits mid-range. Oversized, high-cycle or custom-weight doors run higher.
This is a range, not a quote. The exact price comes after we see the door and you approve it before any work starts. Call (469) 281-7750 and describe what it is doing.
Colleyville at a glance
- County
- Tarrant County
- Drive from our Coppell base
- About 25 minutes from our Coppell base
- Postcodes covered
- 76034
- Around
- Colleyville Nature Center, Village at Colleyville, McPherson Park
Before we get there
A torsion spring stores enough energy to cause serious injury. It should only be unwound, adjusted or replaced with proper winding bars by someone trained to use them. This is not a do it yourself repair at any skill level.
About Colleyville
Side entry garages are common here, which puts the door in view from the street at an angle.
Tarrant County. About 25 minutes from our Coppell base.
What that means for a door here
A side entry garage puts the door in view from the street at an angle, so in Colleyville a panel that almost matches is a visible problem rather than a hidden one.
We work throughout Colleyville, including the neighbourhoods around Colleyville Nature Center, Village at Colleyville, McPherson Park.
Get a price
Tell us about your Colleyville door
If the door is stuck open or will not close, call. That is a security problem and the phone is faster than anything else on this page. We are about 25 minutes away, and Colleyville sits in Tarrant County.
A person answers 7am to 11pm.
Questions
Springs in Colleyville, asked and answered
Do you cover Colleyville?
Yes. Colleyville is in Tarrant County, and it is one of the 32 cities covered from the Coppell base. About 25 minutes from our Coppell base. That covers postcode 76034.
What usually fails on a Colleyville door?
A broken torsion spring shows as a gap of an inch or two in the coil, usually visible from the floor by looking at the shaft above the door. The break often announces itself as a single loud bang from an empty garage. After it, the opener may hum and move the trolley while the door stays on the floor.
How long does garage door spring replacement take in Colleyville?
Usually under two hours from arrival. The stationary cones of a torsion assembly bolt to a spring anchor bracket fastened into the header above the opening. On a 16 foot door that bracket resists the torque of both springs. Lag screws pulling out of a split or shimmed header let the bracket shift, which shows up as the shaft climbing away from the wall when the door is closed.
Is the work guaranteed?
Parts and labour carry a 5 year warranty. The price is agreed before any work starts, and the on site estimate is free.
Is there anything specific about garage doors in Colleyville?
Side entry garages are common here, which puts the door in view from the street at an angle. Doors of that period are commonly seven feet tall, built from four sections of about twenty one inches. Winding follows door height rather than width: on standard drums a seven foot door takes roughly seven and a half turns, and an eight foot door about a turn more. Turns set the balance, so a correctly sized spring wound short still leaves the door out of balance.
Get it fixed
Get a springs price for your Colleyville door
Tell us what it is doing. The estimate on site is free.