Jump to a service
North Richland Hills, TX
Garage door spring replacement in North Richland Hills, Texas
A broken torsion spring is the most common reason a door stops lifting. The fix is a matched pair sized to what the door actually weighs, not the cheapest spring that fits the shaft.
A torsion spring stores enough energy to cause serious injury. It should only be unwound, adjusted or replaced with proper winding bars by someone trained to use them. This is not a do it yourself repair at any skill level.
Springs in North Richland Hills
North Richland Hills changes era from one half of the city to the other, on streets that look much the same from the kerb. Some doors of that period carry an enclosed counterbalance, with the torsion spring running inside a steel tube above the opening and wound through a fitting at one end rather than with bars. A spring that fails inside the tube leaves nothing visible from the floor. The first sign is a door the opener can no longer lift. Garages built in the 1950s and 1960s were commonly fitted with extension springs running along the horizontal tracks, one on each side, rather than a torsion shaft over the opening. Extension springs stretch and relax with every cycle and rely on pulleys and a cable for balance. Many of those doors have since been converted to torsion, so the original hardware is not a given. Usually under two hours from arrival.
What that means for a North Richland Hills door
Opener force settings are adjusted to a door as it was balanced on the day of the setting. Replace a spring and the effort curve changes, so limits and force should be checked again afterward. A door that reverses partway down or stops short of the floor is often running settings left over from a tired spring rather than reporting a track fault. Anything added to a door changes what the springs have to balance. An insulation kit bonded to the inside of single layer panels adds weight the original spring was not wound for, and so does a replacement section with glass in it. The door usually still opens, but the balance point moves and the opener works harder on every cycle.
Signs you are dealing with this
- The door slams down rather than lowering under control
- A loud bang from the garage, then the door will not open
What we check on arrival
- Door balance after installation, tested by hand at three heights
- Spring wire size, inside diameter and length to confirm correct sizing
$200 to $450
A standard pair of torsion springs on a two-car door sits mid-range. Oversized, high-cycle or custom-weight doors run higher.
This is a range, not a quote. The exact price comes after we see the door and you approve it before any work starts. Call (469) 281-7750 and describe what it is doing.
North Richland Hills at a glance
- County
- Tarrant County
- Drive from our Coppell base
- About 35 minutes from our Coppell base
- Postcodes covered
- 76180, 76182
- Around
- NRH2O Family Water Park, Iron Horse Golf Course, NRH Centre
Before we get there
A torsion spring stores enough energy to cause serious injury. It should only be unwound, adjusted or replaced with proper winding bars by someone trained to use them. This is not a do it yourself repair at any skill level.
About North Richland Hills
The southern half of the city carries much older hardware than the northern half.
Tarrant County. About 35 minutes from our Coppell base.
What that means for a door here
North Richland Hills changes era from one half of the city to the other, on streets that look much the same from the kerb.
We work throughout North Richland Hills, including the neighbourhoods around NRH2O Family Water Park, Iron Horse Golf Course, NRH Centre.
Get a price
Tell us about your North Richland Hills door
If the door is stuck open or will not close, call. That is a security problem and the phone is faster than anything else on this page. We are about 35 minutes away, and North Richland Hills sits in Tarrant County.
A person answers 7am to 11pm.
Questions
Springs in North Richland Hills, asked and answered
Do you cover North Richland Hills?
Yes. North Richland Hills is in Tarrant County, and it is one of the 32 cities covered from the Coppell base. About 35 minutes from our Coppell base. That covers postcodes 76180, 76182.
What usually fails on a North Richland Hills door?
Torsion springs are handed. A left wound spring and a right wound spring are not interchangeable, and the winding cones are commonly colored to show which is which, red for left wound and black for right wound. On a two spring shaft one of each is fitted, mounted either side of the center bracket, so a matched pair means matched in hand as well as in size.
How long does garage door spring replacement take in North Richland Hills?
Usually under two hours from arrival. The stationary cones of a torsion assembly bolt to a spring anchor bracket fastened into the header above the opening. On a 16 foot door that bracket resists the torque of both springs. Lag screws pulling out of a split or shimmed header let the bracket shift, which shows up as the shaft climbing away from the wall when the door is closed.
Is the work guaranteed?
Parts and labour carry a 5 year warranty. The price is agreed before any work starts, and the on site estimate is free.
Is there anything specific about garage doors in North Richland Hills?
The southern half of the city carries much older hardware than the northern half. Leftover parts on the horizontal track tell whether a door was converted from extension springs to torsion. Pulley brackets and an empty rear hanger near the back of the track are what stays behind. A conversion brings a shaft, end bearing plates, drums and cables with it, so the hardware above the opening is often newer than the door below it.
Get it fixed
Get a springs price for your North Richland Hills door
Tell us what it is doing. The estimate on site is free.