Jump to a service
Richardson, TX
Garage door spring replacement in Richardson, Texas
A broken torsion spring is the most common reason a door stops lifting. The fix is a matched pair sized to what the door actually weighs, not the cheapest spring that fits the shaft.
A torsion spring stores enough energy to cause serious injury. It should only be unwound, adjusted or replaced with proper winding bars by someone trained to use them. This is not a do it yourself repair at any skill level.
Springs in Richardson
Richardson's mid century openings are often a non standard width, so an off the shelf door needs framing work before it will fit properly. Steel got thinner as the decades passed. A single layer door pressed in the 1970s uses a heavier gauge than a current builder panel of the same size, and it weighs accordingly. Sizing a spring from a chart keyed to door width and height can therefore come out light on an older door. Two doors of identical size from different decades are not the same load. Garages built in the 1950s and 1960s were commonly fitted with extension springs running along the horizontal tracks, one on each side, rather than a torsion shaft over the opening. Extension springs stretch and relax with every cycle and rely on pulleys and a cable for balance. Many of those doors have since been converted to torsion, so the original hardware is not a given. Usually under two hours from arrival.
What that means for a Richardson door
Extension springs on doors from the 1970s and 1980s should carry a containment cable threaded through the center of the spring. Without it, a spring that fails under tension can travel across the garage. Retrofit containment cables fit older assemblies. Torsion conversions became more common on doors built after this period, which is why hardware varies house to house in the same tract. An 8 foot single door often runs one torsion spring where a 16 foot door runs a pair. That single spring has no partner to share the load, so the door drops hard when it breaks and the opener cannot lift it at all. Some single doors of this width still use extension springs stretched along the horizontal tracks instead.
Signs you are dealing with this
- A loud bang from the garage, then the door will not open
- A visible gap in the coil of the spring above the door
What we check on arrival
- Whether the existing springs were correctly specified for the door weight
- Cable and drum condition, since a broken spring often damages both
$200 to $450
A standard pair of torsion springs on a two-car door sits mid-range. Oversized, high-cycle or custom-weight doors run higher.
This is a range, not a quote. The exact price comes after we see the door and you approve it before any work starts. Call (469) 281-7750 and describe what it is doing.
Richardson at a glance
- County
- Dallas County
- Drive from our Coppell base
- About 30 minutes from our Coppell base
- Postcodes covered
- 75080, 75081, 75082
- Around
- Telecom Corridor, Cottonwood Park, UT Dallas
Before we get there
A torsion spring stores enough energy to cause serious injury. It should only be unwound, adjusted or replaced with proper winding bars by someone trained to use them. This is not a do it yourself repair at any skill level.
About Richardson
Original mid century door openings are frequently non standard widths.
Dallas County. About 30 minutes from our Coppell base.
What that means for a door here
Richardson's mid century openings are often a non standard width, so an off the shelf door needs framing work before it will fit properly.
We work throughout Richardson, including the neighbourhoods around Telecom Corridor, Cottonwood Park, UT Dallas.
Get a price
Tell us about your Richardson door
If the door is stuck open or will not close, call. That is a security problem and the phone is faster than anything else on this page. We are about 30 minutes away, and Richardson sits in Dallas County.
A person answers 7am to 11pm.
Questions
Springs in Richardson, asked and answered
Do you cover Richardson?
Yes. Richardson is in Dallas County, and it is one of the 32 cities covered from the Coppell base. About 30 minutes from our Coppell base. That covers postcodes 75080, 75081, 75082.
What usually fails on a Richardson door?
With the trolley released from the opener, a correctly balanced door can be raised by hand with steady effort and will hold position around halfway without being held. A door that sinks or climbs on its own is out of balance, and no adjustment at the opener corrects it. The test only means anything with the opener disconnected.
How long does garage door spring replacement take in Richardson?
Usually under two hours from arrival. Torsion springs fail by fatigue at the surface of the wire, so anything that pits that surface shortens the cycle life. Rust from an unheated garage does exactly that. A light coat of oil wiped along the coils slows corrosion and cuts the friction between coils as they wind, which is also what quiets the groan some doors make on the first few feet of lift.
Is the work guaranteed?
Parts and labour carry a 5 year warranty. The price is agreed before any work starts, and the on site estimate is free.
Is there anything specific about garage doors in Richardson?
Original mid century door openings are frequently non standard widths. A broken torsion spring shows as a gap of an inch or two in the coil, usually visible from the floor by looking at the shaft above the door. The break often announces itself as a single loud bang from an empty garage. After it, the opener may hum and move the trolley while the door stays on the floor.
Get it fixed
Get a springs price for your Richardson door
Tell us what it is doing. The estimate on site is free.