Jump to a service
Dallas, TX
Garage door spring replacement in Dallas, Texas
A broken torsion spring is the most common reason a door stops lifting. The fix is a matched pair sized to what the door actually weighs, not the cheapest spring that fits the shaft.
A torsion spring stores enough energy to cause serious injury. It should only be unwound, adjusted or replaced with proper winding bars by someone trained to use them. This is not a do it yourself repair at any skill level.
Springs in Dallas
In older Dallas neighbourhoods the header and jambs are frequently older than the door hanging on them, so the structure gets checked before anything gets quoted. Garages built in the 1950s and 1960s were commonly fitted with extension springs running along the horizontal tracks, one on each side, rather than a torsion shaft over the opening. Extension springs stretch and relax with every cycle and rely on pulleys and a cable for balance. Many of those doors have since been converted to torsion, so the original hardware is not a given. Anything added to a door changes what the springs have to balance. An insulation kit bonded to the inside of single layer panels adds weight the original spring was not wound for, and so does a replacement section with glass in it. The door usually still opens, but the balance point moves and the opener works harder on every cycle. Usually under two hours from arrival.
What that means for a Dallas door
Torsion springs fail by fatigue at the surface of the wire, so anything that pits that surface shortens the cycle life. Rust from an unheated garage does exactly that. A light coat of oil wiped along the coils slows corrosion and cuts the friction between coils as they wind, which is also what quiets the groan some doors make on the first few feet of lift. One piece tilt up doors do not use a torsion shaft above the opening. The springs mount on the jambs and work with the pivot arms, so the balance point changes as the slab swings out. Hardware for jamb mounted spring systems is not interchangeable with sectional torsion parts, and the geometry of the arm matters as much as the spring rating.
Signs you are dealing with this
- The door slams down rather than lowering under control
- A loud bang from the garage, then the door will not open
What we check on arrival
- Spring wire size, inside diameter and length to confirm correct sizing
- Whether the existing springs were correctly specified for the door weight
$200 to $450
A standard pair of torsion springs on a two-car door sits mid-range. Oversized, high-cycle or custom-weight doors run higher.
This is a range, not a quote. The exact price comes after we see the door and you approve it before any work starts. Call (469) 281-7750 and describe what it is doing.
Dallas at a glance
- County
- Dallas County
- Drive from our Coppell base
- About 30 minutes from our Coppell base
- Postcodes covered
- 75201, 75206, 75214, 75218, 75220, 75225, 75228, 75230, 75243
- Around
- Bishop Arts District, White Rock Lake, Deep Ellum
Before we get there
A torsion spring stores enough energy to cause serious injury. It should only be unwound, adjusted or replaced with proper winding bars by someone trained to use them. This is not a do it yourself repair at any skill level.
About Dallas
Detached alley garages in the older neighbourhoods often have no opener at all, or one added decades later with improvised bracing.
Dallas County. About 30 minutes from our Coppell base.
What that means for a door here
In older Dallas neighbourhoods the header and jambs are frequently older than the door hanging on them, so the structure gets checked before anything gets quoted.
We work throughout Dallas, including the neighbourhoods around Bishop Arts District, White Rock Lake, Deep Ellum.
Get a price
Tell us about your Dallas door
If the door is stuck open or will not close, call. That is a security problem and the phone is faster than anything else on this page. We are about 30 minutes away, and Dallas sits in Dallas County.
A person answers 7am to 11pm.
Questions
Springs in Dallas, asked and answered
Do you cover Dallas?
Yes. Dallas is in Dallas County, and it is one of the 32 cities covered from the Coppell base. About 30 minutes from our Coppell base. That covers postcodes 75201, 75206, 75214, 75218, 75220, 75225, 75228, 75230, 75243.
What usually fails on a Dallas door?
Photo eyes have been required on residential garage door openers sold in the United States since 1993. Units older than that reverse only when the door meets enough resistance, and that resistance depends on the springs carrying the door properly. A board laid flat on the floor under the door checks whether the opener still reverses on contact.
How long does garage door spring replacement take in Dallas?
Usually under two hours from arrival. A wood door that is still original has not weighed the same all its life. Timber takes on moisture in a damp garage and gives it back in dry months, and layers of paint add to the section over the years. The spring was wound for the door as it left the shop. The same door can sit differently in a wet season than in a dry one.
Is the work guaranteed?
Parts and labour carry a 5 year warranty. The price is agreed before any work starts, and the on site estimate is free.
Is there anything specific about garage doors in Dallas?
Detached alley garages in the older neighbourhoods often have no opener at all, or one added decades later with improvised bracing. A garage door opener is sized to move a balanced door, not to lift a dead weight. Openers are typically half to three quarter horsepower, which is enough only while the springs carry the door. When a spring weakens, the opener strains, and on older units without modern force sensing it keeps pulling until something in the drive gives out.
Get it fixed
Get a springs price for your Dallas door
Tell us what it is doing. The estimate on site is free.