Jump to a service
Dallas County, TX
Garage door repair in Richardson, Texas
Most faults announce themselves before they strand anyone. A door that hesitates, reverses part way down or runs crooked is naming a specific failed component, and the diagnosis decides the repair rather than the other way round.
If the door is stuck part way and you can hear tension in the springs, leave it alone. A door under load can drop without warning.
Garage doors in Richardson
Original mid century door openings are frequently non standard widths. Richardson's mid century openings are often a non standard width, so an off the shelf door needs framing work before it will fit properly. Where a door reverses tells more than the fact that it reversed. A stop at the same height on every cycle points at something physical waiting at that height, such as a dented track or a hinge that has spread. A stop at a different height each time is a force or balance problem, since that resistance builds gradually instead of at one fixed spot.
Garage doors in Richardson
Plenty of doors still carry a manual slide lock through the vertical track, left over from the years before openers were standard. An engaged lock and a running opener meet head on, and what gives is the bar or the top section around the arm. Where an opener is in service the latch is normally disabled or unbolted rather than left for someone to throw out of habit. Garages built in the 1960s and 1970s commonly still carry wood doors or early sectional steel on extension springs, with the original jamb hardware. Extension spring systems of that period were often installed without containment cables, so a broken spring can travel. Track is frequently light gauge, and the header may never have been sized for a later replacement door.
Start here
What is the door in Richardson doing?
You do not need to know the name of the part. Find the line that matches and we will take it from there.
- There was a bang like a gunshot and now it will not lift That noise is nearly always a torsion spring letting go Garage door spring replacement in Richardson
- The motor runs but the door does not move Usually a stripped drive gear or a trolley that has come disconnected Garage door opener repair and installation in Richardson
- It closes most of the way then goes back up Almost always the photo eyes near the floor, or a travel limit setting Garage door opener repair and installation in Richardson
- It is hanging crooked, or one side has come off the rail A cable, roller or track problem. The door is carrying load somewhere it should not Garage door cable and track repair in Richardson
- There is a cable dangling or coiled up at the bottom A lift cable has come off its drum or snapped, so the two sides are no longer balanced Garage door cable and track repair in Richardson
- It opens a few inches then stops Could be spring tension, a track obstruction or a force setting. It needs looking at rather than guessing Garage door repair in Richardson
- One side lifts faster than the other Uneven lift means one cable or drum is out of adjustment Garage door cable and track repair in Richardson
- Something hit it and there is a dent in one section Often one panel rather than a whole door, depending on whether that section is still made Garage door panel replacement in Richardson
- It has got really loud over the last year Worn roller bearings and dry hinges, not the motor Garage door tune up and maintenance in Richardson
- It works from the wall button but not the remote Remote, receiver or antenna rather than the door itself Garage door opener repair and installation in Richardson
- It will not stay open, it slides back down on its own The springs are no longer counterbalancing the door weight Garage door spring replacement in Richardson
- The door is old, ugly, and the garage is unbearable in summer An insulated replacement, and the measuring comes before the catalogue New garage door installation in Richardson
- Nothing has broken but it has never been serviced The cheapest visit there is, and the one that finds the thing that would have stranded you Garage door tune up and maintenance in Richardson
- A bay door or dock door has stopped at our premises Rolling steel, sectional and dock equipment, where downtime usually costs more than the part Commercial garage door service in Richardson
What we work on in Richardson
- Same day Garage door spring replacement in Richardson $200 to $450 Details
- Garage door opener repair and installation in Richardson $175 to $700 Details
- New garage door installation in Richardson $1100 to $4500 Details
- Same day Garage door cable and track repair in Richardson $150 to $450 Details
- Garage door panel replacement in Richardson $350 to $1400 Details
- Garage door tune up and maintenance in Richardson $99 to $199 Details
- Same day Commercial garage door service in Richardson $300 to $6000 Details
Richardson at a glance
- County
- Dallas County
- Drive from our Coppell base
- About 30 minutes from our Coppell base
- Postcodes covered
- 75080, 75081, 75082
- Around
- Telecom Corridor, Cottonwood Park, UT Dallas
About Richardson
Original mid century door openings are frequently non standard widths.
Dallas County. About 30 minutes from our Coppell base.
What that means for a door here
Richardson's mid century openings are often a non standard width, so an off the shelf door needs framing work before it will fit properly.
We work throughout Richardson, including the neighbourhoods around Telecom Corridor, Cottonwood Park, UT Dallas.
Get a price
Tell us about your Richardson door
Describe what the door is doing and somebody will call you back. The estimate on site is free. We are about 30 minutes away, and Richardson sits in Dallas County.
A person answers 7am to 11pm.
Questions
Garage door repair in Richardson, asked and answered
Do you cover Richardson?
Yes. Richardson is in Dallas County, and it is one of the 32 cities covered from the Coppell base. About 30 minutes from our Coppell base. That covers postcodes 75080, 75081, 75082.
What usually fails on a Richardson door?
Single layer steel has a thin skin and no backing, so damage shows as denting and as section edges that flex where a strut should be. Hinge holes elongate at the end stiles because there is little metal around them. The door stays light, which keeps spring and opener load low but does nothing for panel stiffness.
How long does garage door repair take in Richardson?
Most repairs take one to two hours on site. Openings that do not match a stock width or height change what a repair can do. A door cut down or shimmed to fit leaves track and jamb hardware in positions the manufacturer did not intend, and replacement sections may not line up with existing hinges. Measuring the rough opening and the headroom comes before any part is ordered.
Is the work guaranteed?
Parts and labour carry a 5 year warranty. The price is agreed before any work starts, and the on site estimate is free.
Is there anything specific about garage doors in Richardson?
Original mid century door openings are frequently non standard widths. Single width doors are light enough that many were hung on extension springs stretched along the horizontal track. A stretched spring loses lift gradually, so the door feels normal until it does not, and the cable is what usually shows the wear first. Containment cables running through the spring interior keep a break from becoming a projectile.
Get it fixed
A door in Richardson that will not behave?
About 30 minutes from our Coppell base. The estimate on site is free.