Jump to a service
Richardson, TX
Garage door opener repair and installation in Richardson, Texas
An opener that runs without moving the door, or sends it back up on the way down, is usually a stripped gear, a disconnected trolley or a photo eye out of alignment rather than a dead motor.
Openers in Richardson
Richardson's mid century openings are often a non standard width, so an off the shelf door needs framing work before it will fit properly. An opener from the 1970s answers a transmitter code that never varies, and the head has a pair of low voltage terminals for the wall button. Wiring a separate rolling code receiver to those terminals gives the door current transmitters while the motor stays in place. The original fixed code stays valid unless the internal receiver is disabled, so old remotes keep working. Openers with battery backup keep running through a power failure by drawing on a sealed battery inside the head unit. That battery is a consumable and loses capacity with age, which the opener reports through a status light before it stops holding a charge. Some units run the door at reduced speed on battery and hold the courtesy light dim to save it. Repairs run about an hour, a full replacement two to three.
What that means for a Richardson door
Photo eyes sit within six inches of the floor on both jambs and have to face each other squarely. Low winter sun entering a single width opening can wash out the receiving lens and read as a blocked beam, which shows up as a door that reverses only at certain hours. A steady indicator light confirms alignment. Chain drive openers pull the trolley with a metal chain over a sprocket and are the loudest of the common types. Belt drive substitutes a reinforced rubber belt and runs noticeably quieter. Screw drive turns a threaded steel rod with fewer moving parts, though its lubricant thickens in cold weather and the unit slows until it warms.
Signs you are dealing with this
- The wall button works but the remotes do not
- A grinding noise from the motor housing
What we check on arrival
- Travel limit and force settings against the actual door
- Remote and keypad programming, and rolling code security
$175 to $700
A sensor alignment or limit adjustment is at the bottom of the range. A new belt-drive or wall-mount opener installed is at the top.
This is a range, not a quote. The exact price comes after we see the door and you approve it before any work starts. Call (469) 281-7750 and describe what it is doing.
Richardson at a glance
- County
- Dallas County
- Drive from our Coppell base
- About 30 minutes from our Coppell base
- Postcodes covered
- 75080, 75081, 75082
- Around
- Telecom Corridor, Cottonwood Park, UT Dallas
Before we get there
Never disable or bypass the photo eyes to make a door close. They are federally required entrapment protection, and a door that will not close is telling you something is wrong.
About Richardson
Original mid century door openings are frequently non standard widths.
Dallas County. About 30 minutes from our Coppell base.
What that means for a door here
Richardson's mid century openings are often a non standard width, so an off the shelf door needs framing work before it will fit properly.
We work throughout Richardson, including the neighbourhoods around Telecom Corridor, Cottonwood Park, UT Dallas.
How garage door opener repair and installation works, in full
Get a price
Tell us about your Richardson door
Describe what the door is doing and somebody will call you back. The estimate on site is free. We are about 30 minutes away, and Richardson sits in Dallas County.
A person answers 7am to 11pm.
Questions
Openers in Richardson, asked and answered
Do you cover Richardson?
Yes. Richardson is in Dallas County, and it is one of the 32 cities covered from the Coppell base. About 30 minutes from our Coppell base. That covers postcodes 75080, 75081, 75082.
What usually fails on a Richardson door?
Exterior keypads mount on the jamb and speak to the same receiver as the remotes, so a keypad that has lost its code is reprogrammed at the learn button on the opener head rather than at the wall station. The battery compartment faces weather and corrodes, and crusted contacts account for a keypad that answers only sometimes in cold conditions.
How long does garage door opener repair and installation take in Richardson?
Repairs run about an hour, a full replacement two to three. Garages raised before the 1960s were sized for a narrow single car, and the depth behind the opening is what limits a trolley opener rather than the door itself. The rail runs back beyond the fully raised door and needs clear length past it. Storage platforms and later additions eat that space, which is why the backroom gets measured before a unit is chosen.
Is the work guaranteed?
Parts and labour carry a 5 year warranty. The price is agreed before any work starts, and the on site estimate is free.
Is there anything specific about garage doors in Richardson?
Original mid century door openings are frequently non standard widths. Every remote and keypad ever taught to an opener stays in receiver memory until that memory is cleared. Holding the learn button until the indicator goes out wipes all of them at once, after which each transmitter still in use has to be taught again. The stored list matters when a remote goes missing or a property changes hands.
Get it fixed
Get a openers price for your Richardson door
Tell us what it is doing. The estimate on site is free.