Jump to a service
Richardson, TX
Commercial garage door service in Richardson, Texas
Rolling steel, sectional and dock equipment fail differently from a house door, because they cycle twenty or thirty times a day rather than four. Downtime, not the part, is usually the real cost.
A rolling steel door carries its spring inside the barrel at a tension far above a residential torsion spring. Barrel work is not a maintenance task.
Commercial in Richardson
Richardson's mid century openings are often a non standard width, so an off the shelf door needs framing work before it will fit properly. Shop and workshop doors of that age were often hung on three inch track where a house door uses two inch, and the two families do not share rollers or hinges. A roller stem cut for the narrower channel rattles in the wider one. Track width is read across the open face of the channel before any hardware is ordered. Residential openers are built to intermittent duty, meaning the motor is expected to run briefly and then rest. Commercial operators are rated for continuous duty service and use a different motor and a control scheme that supports three button stations and safety edges. Putting a residential unit on a door that cycles all day overheats the motor and wears the gear set. Varies by door type, quoted after the site assessment.
What that means for a Richardson door
Wide openings run two springs on one shaft, and the shaft passes through a center bearing plate lagged to the header between them. On longer shafts a coupling joins two lengths, and a coupling that has loosened lets one half turn slightly before the other. The symptom is a door that starts crooked and squares up partway through the lift. Fire rated curtains of that age are commonly held by a fusible link that has to reach its melting point before anything moves, so smoke on its own will not close the door. Release triggered from the alarm panel is a later arrangement. The link is a consumable as well, replaced after it operates rather than reset like a switch.
Signs you are dealing with this
- A dock or bay door is stuck open and the building is not secure
- A rolling steel door has jammed partway in its curtain
What we check on arrival
- Cycle count and whether the current hardware suits the usage
- Fire door drop tests and release mechanisms where applicable
$300 to $6000
A service call and adjustment is at the low end. Rolling steel door replacement and dock equipment work runs to the top of the range and beyond.
This is a range, not a quote. The exact price comes after we see the door and you approve it before any work starts. Call (469) 281-7750 and describe what it is doing.
Richardson at a glance
- County
- Dallas County
- Drive from our Coppell base
- About 30 minutes from our Coppell base
- Postcodes covered
- 75080, 75081, 75082
- Around
- Telecom Corridor, Cottonwood Park, UT Dallas
Before we get there
A rolling steel door carries its spring inside the barrel at a tension far above a residential torsion spring. Barrel work is not a maintenance task.
About Richardson
Original mid century door openings are frequently non standard widths.
Dallas County. About 30 minutes from our Coppell base.
What that means for a door here
Richardson's mid century openings are often a non standard width, so an off the shelf door needs framing work before it will fit properly.
We work throughout Richardson, including the neighbourhoods around Telecom Corridor, Cottonwood Park, UT Dallas.
Get a price
Tell us about your Richardson door
If the door is stuck open or will not close, call. That is a security problem and the phone is faster than anything else on this page. We are about 30 minutes away, and Richardson sits in Dallas County.
A person answers 7am to 11pm.
Questions
Commercial in Richardson, asked and answered
Do you cover Richardson?
Yes. Richardson is in Dallas County, and it is one of the 32 cities covered from the Coppell base. About 30 minutes from our Coppell base. That covers postcodes 75080, 75081, 75082.
What usually fails on a Richardson door?
A trade run from a house puts commercial duty on residential hardware. A van loaded and unloaded through the garage can take a door through many more cycles in a day than a household pattern assumes. High cycle springs and sealed bearing rollers fit the same brackets and the same opening, so the upgrade is a parts choice rather than a new door.
How long does commercial garage door service take in Richardson?
Varies by door type, quoted after the site assessment. A sensing edge runs the full width of the bottom section and reverses the door when it is compressed by anything in the opening. It is standard on commercial operators where a photo beam alone cannot see a low object across a wide bay. The edge is wired back to the operator through a coil cord or a wireless transmitter, and both wear at the door end.
Is the work guaranteed?
Parts and labour carry a 5 year warranty. The price is agreed before any work starts, and the on site estimate is free.
Is there anything specific about garage doors in Richardson?
Original mid century door openings are frequently non standard widths. Light gauge single layer steel doors turn up on small workshop and storage units as often as on houses. The door looks the same from outside, but the duty is not. Panel skins dent from forklift and trolley contact, and the hinges wear at a rate set by the traffic rather than by the age of the building.
Get it fixed
Get a commercial price for your Richardson door
Tell us what it is doing. The estimate on site is free.