Jump to a service
Plano, TX
Garage door spring replacement in Plano, Texas
A broken torsion spring is the most common reason a door stops lifting. The fix is a matched pair sized to what the door actually weighs, not the cheapest spring that fits the shaft.
A torsion spring stores enough energy to cause serious injury. It should only be unwound, adjusted or replaced with proper winding bars by someone trained to use them. This is not a do it yourself repair at any skill level.
Springs in Plano
Spring life is counted in cycles rather than years, and West Plano's 1980s and 1990s build era has now had enough of them to reach the end of it. Doors of that period are commonly seven feet tall, built from four sections of about twenty one inches. Winding follows door height rather than width: on standard drums a seven foot door takes roughly seven and a half turns, and an eight foot door about a turn more. Turns set the balance, so a correctly sized spring wound short still leaves the door out of balance. Winding cones take steel winding bars sized to the holes in the cone, and anything else, including screwdrivers and rebar, slips out under load. The set screws bite into the shaft itself, so a shaft already dimpled from earlier work gives them less to hold. Chalk drawn along a wound shaft shows at a glance whether a cone has since slipped. Usually under two hours from arrival.
What that means for a Plano door
The red release cord drops the door off the opener trolley so it can be worked by hand. With a broken spring, that hand is holding the whole door, and a double door in that state is beyond what one person should lift. A door already up when the spring fails should be left up and blocked rather than pulled down. A 16 foot torsion assembly rides in an end bearing plate at each side of the opening and usually a center bearing at the anchor bracket. Bearings that have lost their grease squeal on every cycle and let the shaft move in its race. A worn race also lets the shaft wear a groove, and a grooved shaft keeps eating bearings after they are replaced.
Signs you are dealing with this
- The door is far too heavy to lift by hand
- The opener strains, hums, or lifts the door a few inches and quits
What we check on arrival
- Spring wire size, inside diameter and length to confirm correct sizing
- Whether the existing springs were correctly specified for the door weight
$200 to $450
A standard pair of torsion springs on a two-car door sits mid-range. Oversized, high-cycle or custom-weight doors run higher.
This is a range, not a quote. The exact price comes after we see the door and you approve it before any work starts. Call (469) 281-7750 and describe what it is doing.
Plano at a glance
- County
- Collin County
- Drive from our Coppell base
- About 35 minutes from our Coppell base
- Postcodes covered
- 75023, 75024, 75025, 75074, 75075, 75093
- Around
- Downtown Plano Arts District, Legacy West, Oak Point Park
Before we get there
A torsion spring stores enough energy to cause serious injury. It should only be unwound, adjusted or replaced with proper winding bars by someone trained to use them. This is not a do it yourself repair at any skill level.
About Plano
West Plano is dense with 1980s and 1990s two car garages running original or first replacement hardware.
Collin County. About 35 minutes from our Coppell base.
What that means for a door here
Spring life is counted in cycles rather than years, and West Plano's 1980s and 1990s build era has now had enough of them to reach the end of it.
We work throughout Plano, including the neighbourhoods around Downtown Plano Arts District, Legacy West, Oak Point Park.
Get a price
Tell us about your Plano door
If the door is stuck open or will not close, call. That is a security problem and the phone is faster than anything else on this page. We are about 35 minutes away, and Plano sits in Collin County.
A person answers 7am to 11pm.
Questions
Springs in Plano, asked and answered
Do you cover Plano?
Yes. Plano is in Collin County, and it is one of the 32 cities covered from the Coppell base. About 35 minutes from our Coppell base. That covers postcodes 75023, 75024, 75025, 75074, 75075, 75093.
What usually fails on a Plano door?
Single layer steel doors sit at the light end of the residential weight range, so their springs store less energy than an insulated door of the same width. The correct replacement is still read off the old spring: wire diameter, inside diameter, length, and wind direction. Door width alone does not determine the spring, because panel construction changes the weight it has to balance.
How long does garage door spring replacement take in Plano?
Usually under two hours from arrival. A 16 foot double door weighs roughly 150 to 250 pounds depending on panel construction, and the torsion assembly above the header carries all of it. Most double doors of this width run a pair of springs on a shared shaft. When one breaks the other is usually near the end of its life, since both were wound the same day and cycled the same number of times.
Is the work guaranteed?
Parts and labour carry a 5 year warranty. The price is agreed before any work starts, and the on site estimate is free.
Is there anything specific about garage doors in Plano?
West Plano is dense with 1980s and 1990s two car garages running original or first replacement hardware. An insulated steel door carries polystyrene or polyurethane between two skins, which adds weight over a single layer panel of identical width. Springs have to be wound for that extra load. Fitting a spring specified for a lighter door leaves the door heavy at the floor and drifting closed from waist height, and it shortens the opener's working life.
Get it fixed
Get a springs price for your Plano door
Tell us what it is doing. The estimate on site is free.