Jump to a service
Colleyville, TX
New garage door installation in Colleyville, Texas
A replacement door is a measuring job before it is a shopping decision. Opening width, headroom, backroom and the weight of the door chosen all decide what track and what spring the installation needs.
New doors in Colleyville
A side entry garage puts the door in view from the street at an angle, so in Colleyville a panel that almost matches is a visible problem rather than a hidden one. Vinyl stop molding with an integral bulb seal became the usual perimeter detail on openings finished in the 2000s, and the bulb does sealing work that a section edge cannot. Rubber compressed against a door for years takes a set and stops recovering. Section thickness decides where the bulb bears, so the molding goes on new with the door. Insulated sections are commonly built at 1 3/8 inches or 2 inches thick, and the thickness sets the joint geometry between sections along with the hinge offset. A thicker section weighs more, so the spring is wound for a different load and the hinge and track package is sized to suit. Section thickness also decides how far the door sits from the jamb seal. A single door replacement is a half day, two doors a full day.
What that means for a Colleyville door
A new door rarely weighs the same as the one it replaces, and an opener holds force settings tuned to the old weight. After installation the up and down force and the travel limits need resetting, and the safety reverse checked against an obstruction. An insulated section adds weight over a single layer panel, which shows up first as an opener that stalls near the top. Hinges on a sectional door are stamped with a number that fixes their position. A number one hinge joins the bottom section to the one above it, and the number rises going up the door, because each hinge higher in the stack needs a deeper offset to keep the section faces flush as they curve into the horizontal track.
Signs you are dealing with this
- The garage is unbearably hot and the door has no insulation
- You are selling and the door is the first thing buyers see
What we check on arrival
- Headroom, backroom and sideroom to confirm which track systems fit
- Header, jamb and framing condition behind the existing door
$1100 to $4500
A standard insulated steel two-car door installed sits in the lower half. Custom sizes, wood or full-view glass doors run above the range.
This is a range, not a quote. The exact price comes after we see the door and you approve it before any work starts. Call (469) 281-7750 and describe what it is doing.
Colleyville at a glance
- County
- Tarrant County
- Drive from our Coppell base
- About 25 minutes from our Coppell base
- Postcodes covered
- 76034
- Around
- Colleyville Nature Center, Village at Colleyville, McPherson Park
Before we get there
The old door still has loaded springs in it. Removal is the dangerous half of an installation, not the fitting.
About Colleyville
Side entry garages are common here, which puts the door in view from the street at an angle.
Tarrant County. About 25 minutes from our Coppell base.
What that means for a door here
A side entry garage puts the door in view from the street at an angle, so in Colleyville a panel that almost matches is a visible problem rather than a hidden one.
We work throughout Colleyville, including the neighbourhoods around Colleyville Nature Center, Village at Colleyville, McPherson Park.
Get a price
Tell us about your Colleyville door
Describe what the door is doing and somebody will call you back. The estimate on site is free. We are about 25 minutes away, and Colleyville sits in Tarrant County.
A person answers 7am to 11pm.
Questions
New doors in Colleyville, asked and answered
Do you cover Colleyville?
Yes. Colleyville is in Tarrant County, and it is one of the 32 cities covered from the Coppell base. About 25 minutes from our Coppell base. That covers postcode 76034.
What usually fails on a Colleyville door?
Doors ordered in volume for subdivisions through the 1990s and 2000s came with builder grade hardware, usually short stem steel rollers turning in light gauge track. The rough opening sets none of that. Longer stem rollers with sealed bearings and nylon tires fit the same jambs, and track gauge and hinge stock are specified apart from the panel design.
How long does new garage door installation take in Colleyville?
A single door replacement is a half day, two doors a full day. Doors past about nine feet wide normally run a pair of torsion springs on a shaft that crosses the header, with a center bearing plate anchored to the wall between them. That plate is the anchor the springs wind against, so it has to land on solid framing. End bearing plates carry the shaft at each side and set where the cable drums sit.
Is the work guaranteed?
Parts and labour carry a 5 year warranty. The price is agreed before any work starts, and the on site estimate is free.
Is there anything specific about garage doors in Colleyville?
Side entry garages are common here, which puts the door in view from the street at an angle. A 16 foot opening is measured in more places than its width. Headroom is the gap between the top of the opening and the ceiling, and it sets whether standard torsion hardware clears or a low headroom conversion is needed. Backroom must take the open door plus the operator rail. Side room carries the vertical track on each jamb.
Get it fixed
Get a new doors price for your Colleyville door
Tell us what it is doing. The estimate on site is free.