Jump to a service
Colleyville, TX
Garage door cable and track repair in Colleyville, Texas
A door hanging crooked, off its rail, or with a cable coiled at the bottom bracket is carrying its load somewhere it was not designed to. That is not a door to keep operating.
A door off its track can fall. Do not run the opener to try to correct it, and keep people and vehicles out from under it until it is secured.
Cables and track in Colleyville
A side entry garage puts the door in view from the street at an angle, so in Colleyville a panel that almost matches is a visible problem rather than a hidden one. Two ways of hanging vertical track are common on doors of that era. Stamped jamb brackets bolt through slots in the track, which allows adjustment and also allows drift once the bolts loosen. A continuous steel angle running the height of the opening holds the track in one plane instead. Doors that come out of alignment repeatedly are often on the bracket method with worn slots. Sectional door hinges are stamped with a number that says where they belong, 1 at the joint nearest the bottom and rising with each joint above it. The number sets how far the roller stem stands off the panel. A hinge fitted in the wrong position pushes that section toward or away from the track and loads one roller against the track lip. Most track and cable work is one to two hours.
What that means for a Colleyville door
Photo eyes sit on brackets clamped to the vertical track a few inches off the floor, so anything that moves the track moves the beam with it. Openers sold in the United States have carried them since 1993. A door that reverses for no clear reason after track work is often reporting a bracket that shifted rather than an obstruction. The lift cable ends at the bottom bracket on each side of the bottom section, and that bracket carries the full pull of the springs whenever the door is closed. Bottom bracket bolts are not general purpose fasteners to loosen for a seal change. On a 16 foot door the two brackets also set how square the bottom edge sits to the floor.
Signs you are dealing with this
- Rollers are jumping out of the rail at the curve
- The rail has a visible bend or a gap at a joint
What we check on arrival
- Vertical and horizontal track for bends, spread and loose fasteners
- Roller stems and bearings on every hinge position
$150 to $450
Resetting a door on its track with new rollers is at the low end. Replacing cables, drums and a bent rail section is at the high end.
This is a range, not a quote. The exact price comes after we see the door and you approve it before any work starts. Call (469) 281-7750 and describe what it is doing.
Colleyville at a glance
- County
- Tarrant County
- Drive from our Coppell base
- About 25 minutes from our Coppell base
- Postcodes covered
- 76034
- Around
- Colleyville Nature Center, Village at Colleyville, McPherson Park
Before we get there
A door off its track can fall. Do not run the opener to try to correct it, and keep people and vehicles out from under it until it is secured.
About Colleyville
Side entry garages are common here, which puts the door in view from the street at an angle.
Tarrant County. About 25 minutes from our Coppell base.
What that means for a door here
A side entry garage puts the door in view from the street at an angle, so in Colleyville a panel that almost matches is a visible problem rather than a hidden one.
We work throughout Colleyville, including the neighbourhoods around Colleyville Nature Center, Village at Colleyville, McPherson Park.
Get a price
Tell us about your Colleyville door
If the door is stuck open or will not close, call. That is a security problem and the phone is faster than anything else on this page. We are about 25 minutes away, and Colleyville sits in Tarrant County.
A person answers 7am to 11pm.
Questions
Cables and track in Colleyville, asked and answered
Do you cover Colleyville?
Yes. Colleyville is in Tarrant County, and it is one of the 32 cities covered from the Coppell base. About 25 minutes from our Coppell base. That covers postcode 76034.
What usually fails on a Colleyville door?
A wood overlay or custom door puts two to three times the weight of a steel door on the same hardware. Heavier doors call for a wider and thicker gauge track with rollers carrying more ball bearings in the race. Cables are sized to the load as well, and a cable specified for a light steel door frays early where it wraps the drum.
How long does garage door cable and track repair take in Colleyville?
Most track and cable work is one to two hours. Horizontal track is hung with a slight downward pitch toward the back of the garage so the door settles against the weatherstrip at the header when it closes. The rear hangers carry that geometry and have to land in framing, not in drywall. Track that sags between hangers shows as a door that hesitates at the curve on the way down.
Is the work guaranteed?
Parts and labour carry a 5 year warranty. The price is agreed before any work starts, and the on site estimate is free.
Is there anything specific about garage doors in Colleyville?
Side entry garages are common here, which puts the door in view from the street at an angle. The opener arm pulls on the top section, and the top section is the only part of the door the opener touches. Heavier insulated panels need that load spread by a reinforcement strut behind the top rail. Without one, the arm works the skin loose around its bolts and the top rollers begin to lean out of the track.
Get it fixed
Get a cables and track price for your Colleyville door
Tell us what it is doing. The estimate on site is free.