Jump to a service
Tarrant County, TX
Garage door repair in Arlington, Texas
Most faults announce themselves before they strand anyone. A door that hesitates, reverses part way down or runs crooked is naming a specific failed component, and the diagnosis decides the repair rather than the other way round.
If the door is stuck part way and you can hear tension in the springs, leave it alone. A door under load can drop without warning.
Garage doors in Arlington
The 1970s and 1980s ranch stock here is remarkably consistent, mostly sixteen foot uninsulated steel doors. Arlington's ranch stock is unusually consistent, mostly sixteen foot uninsulated steel on standard torsion hardware. Steel doors of the 1980s were finished with air dried paint over a light primer rather than the baked coatings used later, so the topcoat chalks and thins under sun. Rust starts at the bottom section where the panel meets a damp slab and works up from the cut edge inward. Once the lowest section perforates around the bracket, refinishing no longer restores it.
Garage doors in Arlington
Where a door reverses tells more than the fact that it reversed. A stop at the same height on every cycle points at something physical waiting at that height, such as a dented track or a hinge that has spread. A stop at a different height each time is a force or balance problem, since that resistance builds gradually instead of at one fixed spot. Struts are the horizontal braces running the full width of a section to stop it bending under its own span. A double width door sags at the middle without them, and that sag reads as daylight along the top edge with the door closed. Sagging also swings the top rollers out of line, so the door drags at the ends of travel.
Start here
What is the door in Arlington doing?
You do not need to know the name of the part. Find the line that matches and we will take it from there.
- There was a bang like a gunshot and now it will not lift That noise is nearly always a torsion spring letting go Garage door spring replacement in Arlington
- The motor runs but the door does not move Usually a stripped drive gear or a trolley that has come disconnected Garage door opener repair and installation in Arlington
- It closes most of the way then goes back up Almost always the photo eyes near the floor, or a travel limit setting Garage door opener repair and installation in Arlington
- It is hanging crooked, or one side has come off the rail A cable, roller or track problem. The door is carrying load somewhere it should not Garage door cable and track repair in Arlington
- There is a cable dangling or coiled up at the bottom A lift cable has come off its drum or snapped, so the two sides are no longer balanced Garage door cable and track repair in Arlington
- It opens a few inches then stops Could be spring tension, a track obstruction or a force setting. It needs looking at rather than guessing Garage door repair in Arlington
- One side lifts faster than the other Uneven lift means one cable or drum is out of adjustment Garage door cable and track repair in Arlington
- Something hit it and there is a dent in one section Often one panel rather than a whole door, depending on whether that section is still made Garage door panel replacement in Arlington
- It has got really loud over the last year Worn roller bearings and dry hinges, not the motor Garage door tune up and maintenance in Arlington
- It works from the wall button but not the remote Remote, receiver or antenna rather than the door itself Garage door opener repair and installation in Arlington
- It will not stay open, it slides back down on its own The springs are no longer counterbalancing the door weight Garage door spring replacement in Arlington
- The door is old, ugly, and the garage is unbearable in summer An insulated replacement, and the measuring comes before the catalogue New garage door installation in Arlington
- Nothing has broken but it has never been serviced The cheapest visit there is, and the one that finds the thing that would have stranded you Garage door tune up and maintenance in Arlington
- A bay door or dock door has stopped at our premises Rolling steel, sectional and dock equipment, where downtime usually costs more than the part Commercial garage door service in Arlington
What we work on in Arlington
- Same day Garage door spring replacement in Arlington $200 to $450 Details
- Garage door opener repair and installation in Arlington $175 to $700 Details
- New garage door installation in Arlington $1100 to $4500 Details
- Same day Garage door cable and track repair in Arlington $150 to $450 Details
- Garage door panel replacement in Arlington $350 to $1400 Details
- Garage door tune up and maintenance in Arlington $99 to $199 Details
- Same day Commercial garage door service in Arlington $300 to $6000 Details
Arlington at a glance
- County
- Tarrant County
- Drive from our Coppell base
- About 45 minutes from our Coppell base
- Postcodes covered
- 76001, 76006, 76010, 76012, 76013, 76015, 76016, 76017
- Around
- AT&T Stadium, Globe Life Field, River Legacy Park
About Arlington
The 1970s and 1980s ranch stock here is remarkably consistent, mostly sixteen foot uninsulated steel doors.
Tarrant County. About 45 minutes from our Coppell base.
What that means for a door here
Arlington's ranch stock is unusually consistent, mostly sixteen foot uninsulated steel on standard torsion hardware.
We work throughout Arlington, including the neighbourhoods around AT&T Stadium, Globe Life Field, River Legacy Park.
Get a price
Tell us about your Arlington door
Describe what the door is doing and somebody will call you back. The estimate on site is free. We are about 45 minutes away, and Arlington sits in Tarrant County.
A person answers 7am to 11pm.
Questions
Garage door repair in Arlington, asked and answered
Do you cover Arlington?
Yes. Arlington is in Tarrant County, and it is one of the 32 cities covered from the Coppell base. About 45 minutes from our Coppell base. That covers postcodes 76001, 76006, 76010, 76012, 76013, 76015, 76016, 76017.
What usually fails on a Arlington door?
Sectional hinges are stamped with a number that fixes where each one belongs. The number climbs with height on the door, and the offset built into the hinge sets how deeply that roller sits in the track. A number two hinge fitted where a number three belongs pulls the section in toward the jamb, which shows as a door scraping down one side.
How long does garage door repair take in Arlington?
Most repairs take one to two hours on site. The opener is the part that stops working, though it is often not the part that is broken. A motor that strains or reverses partway is usually reporting resistance in the door, such as a spring down on turns or a roller binding in bent track. Disconnecting the trolley and moving the door by hand separates the two in under a minute.
Is the work guaranteed?
Parts and labour carry a 5 year warranty. The price is agreed before any work starts, and the on site estimate is free.
Is there anything specific about garage doors in Arlington?
The 1970s and 1980s ranch stock here is remarkably consistent, mostly sixteen foot uninsulated steel doors. A torsion assembly on a double door hangs from a centre bearing plate lagged into the header, with the anchor bracket holding the full wind of the springs. That fastening works in shear on every cycle. Where the header is one flat board, or where the lags caught only sheathing, the plate walks out by degrees and the shaft ends up running out of line.
Get it fixed
A door in Arlington that will not behave?
About 45 minutes from our Coppell base. The estimate on site is free.