Jump to a service
Keller, TX
Garage door cable and track repair in Keller, Texas
A door hanging crooked, off its rail, or with a cable coiled at the bottom bracket is carrying its load somewhere it was not designed to. That is not a door to keep operating.
A door off its track can fall. Do not run the opener to try to correct it, and keep people and vehicles out from under it until it is secured.
Cables and track in Keller
A shop or outbuilding door in Keller is often taller than the standard seven or eight feet, which means high lift track rather than a standard radius. Photo eyes sit on brackets clamped to the vertical track a few inches off the floor, so anything that moves the track moves the beam with it. Openers sold in the United States have carried them since 1993. A door that reverses for no clear reason after track work is often reporting a bracket that shifted rather than an obstruction. Insulated sections weigh more than single skin panels, and that weight passes through the hinges and roller stems into the track. Hinge holes elongate first, which lets a section sag and pulls the roller toward the edge of the track. Track flag brackets on the jamb take the same load and loosen over time in wood framing. Most track and cable work is one to two hours.
What that means for a Keller door
Track and brackets from this period are punched to a manufacturer's own pattern, and the patterns are not shared. A horizontal section of track from one maker bolted to a curve from another leaves the joint a fraction out, which the rollers find on every pass. Matching the existing hardware matters more than matching the nominal size printed on it. Cable drums are cast or extruded aluminum with a spiral groove that the cable follows. Years of load cut a lip into that groove, and the worn edge cuts into a new cable instead of cradling it. A drum that has run with a slack cable often has a flat spot at the top of the spiral where the wrap jumped its lane.
Signs you are dealing with this
- The door binds, catches or scrapes at the same point every time
- Rollers are jumping out of the rail at the curve
What we check on arrival
- Both lift cables end to end, including where they wrap the drums
- Vertical and horizontal track for bends, spread and loose fasteners
$150 to $450
Resetting a door on its track with new rollers is at the low end. Replacing cables, drums and a bent rail section is at the high end.
This is a range, not a quote. The exact price comes after we see the door and you approve it before any work starts. Call (469) 281-7750 and describe what it is doing.
Keller at a glance
- County
- Tarrant County
- Drive from our Coppell base
- About 35 minutes from our Coppell base
- Postcodes covered
- 76244, 76248
- Around
- Keller Town Center, Bear Creek Park, The Keller Pointe
Before we get there
A door off its track can fall. Do not run the opener to try to correct it, and keep people and vehicles out from under it until it is secured.
About Keller
Outbuildings and shop garages here often need a door taller than the standard seven or eight feet.
Tarrant County. About 35 minutes from our Coppell base.
What that means for a door here
A shop or outbuilding door in Keller is often taller than the standard seven or eight feet, which means high lift track rather than a standard radius.
We work throughout Keller, including the neighbourhoods around Keller Town Center, Bear Creek Park, The Keller Pointe.
Get a price
Tell us about your Keller door
If the door is stuck open or will not close, call. That is a security problem and the phone is faster than anything else on this page. We are about 35 minutes away, and Keller sits in Tarrant County.
A person answers 7am to 11pm.
Questions
Cables and track in Keller, asked and answered
Do you cover Keller?
Yes. Keller is in Tarrant County, and it is one of the 32 cities covered from the Coppell base. About 35 minutes from our Coppell base. That covers postcodes 76244, 76248.
What usually fails on a Keller door?
Lift cables are galvanized aircraft cable, and the diameter is chosen for the weight hanging on it. Wear shows first as broken strands, usually at the loop over the bottom bracket pin or at the first wrap on the drum. A cable with one strand gone is on its way out, and the pair is replaced together because both have run the same cycles.
How long does garage door cable and track repair take in Keller?
Most track and cable work is one to two hours. Residential vertical track from this period is commonly graduated rather than parallel to the jamb, with a slight taper along its length so the sections tighten against the weather seal as the door comes down. A track hung dead parallel leaves the door standing off the stop at one end of its travel. The taper is by design rather than a bend in the steel.
Is the work guaranteed?
Parts and labour carry a 5 year warranty. The price is agreed before any work starts, and the on site estimate is free.
Is there anything specific about garage doors in Keller?
Outbuildings and shop garages here often need a door taller than the standard seven or eight feet. The opener arm pulls on the top section, and the top section is the only part of the door the opener touches. Heavier insulated panels need that load spread by a reinforcement strut behind the top rail. Without one, the arm works the skin loose around its bolts and the top rollers begin to lean out of the track.
Get it fixed
Get a cables and track price for your Keller door
Tell us what it is doing. The estimate on site is free.