Jump to a service
Southlake, TX
Garage door cable and track repair in Southlake, Texas
A door hanging crooked, off its rail, or with a cable coiled at the bottom bracket is carrying its load somewhere it was not designed to. That is not a door to keep operating.
A door off its track can fall. Do not run the opener to try to correct it, and keep people and vehicles out from under it until it is secured.
Cables and track in Southlake
A wood overlay door in Southlake can weigh two to three times a standard steel one, which changes the spring calculation completely rather than slightly. Photo eyes sit on brackets clamped to the vertical track a few inches off the floor, so anything that moves the track moves the beam with it. Openers sold in the United States have carried them since 1993. A door that reverses for no clear reason after track work is often reporting a bracket that shifted rather than an obstruction. Three bays under one roof rarely share identical track. Headroom can differ across the span where a truss or a duct crosses one bay, and the doors may have been replaced at different times with different hardware. A roller or bracket that fits the left bay is worth checking against the others before it is treated as the standard part for the garage. Most track and cable work is one to two hours.
What that means for a Southlake door
A sectional door's track comes apart at bolted joints where the vertical meets the curve and the curve meets the horizontal run. Those joints are where alignment is lost first, because each one can slip a little under load. Pulling a slipped joint back into line and tightening it often settles a door that was thought to need new track. A cable coiled loose at the bottom bracket lost tension while the door was moving. That happens when the door lands on an obstruction and one side keeps unwinding, or when a spring breaks mid travel. Rewinding the same cable ignores why it came off, since a scored drum or a bent bottom bracket will unseat it again.
Signs you are dealing with this
- A cable is loose, frayed, or coiled off the drum
- The door binds, catches or scrapes at the same point every time
What we check on arrival
- Roller stems and bearings on every hinge position
- Bottom bracket condition, which is under permanent tension
$150 to $450
Resetting a door on its track with new rollers is at the low end. Replacing cables, drums and a bent rail section is at the high end.
This is a range, not a quote. The exact price comes after we see the door and you approve it before any work starts. Call (469) 281-7750 and describe what it is doing.
Southlake at a glance
- County
- Tarrant County
- Drive from our Coppell base
- About 25 minutes from our Coppell base
- Postcodes covered
- 76092
- Around
- Southlake Town Square, Bob Jones Nature Center, Grapevine Lake
Before we get there
A door off its track can fall. Do not run the opener to try to correct it, and keep people and vehicles out from under it until it is secured.
About Southlake
Custom and wood overlay doors here can weigh two to three times what a standard steel door weighs.
Tarrant County. About 25 minutes from our Coppell base.
What that means for a door here
A wood overlay door in Southlake can weigh two to three times a standard steel one, which changes the spring calculation completely rather than slightly.
We work throughout Southlake, including the neighbourhoods around Southlake Town Square, Bob Jones Nature Center, Grapevine Lake.
Get a price
Tell us about your Southlake door
If the door is stuck open or will not close, call. That is a security problem and the phone is faster than anything else on this page. We are about 25 minutes away, and Southlake sits in Tarrant County.
A person answers 7am to 11pm.
Questions
Cables and track in Southlake, asked and answered
Do you cover Southlake?
Yes. Southlake is in Tarrant County, and it is one of the 32 cities covered from the Coppell base. About 25 minutes from our Coppell base. That covers postcode 76092.
What usually fails on a Southlake door?
Doors taller than a standard opening often run high lift track, where the vertical track continues past the header before the curve. High lift needs matched drums and longer cables, and the drum has to be the right diameter for the added rise. Standard drums on a high lift setup run out of wraps and leave the cable slack near the top.
How long does garage door cable and track repair take in Southlake?
Most track and cable work is one to two hours. Rollers should ride in the track with a little clearance behind the wheel rather than pressed against the back of the channel. Track that sits too close binds the door and wears flats on the wheels. Track set too far out lets the wheel climb the lip on the way past the curve. The gap is set at the brackets on the jamb.
Is the work guaranteed?
Parts and labour carry a 5 year warranty. The price is agreed before any work starts, and the on site estimate is free.
Is there anything specific about garage doors in Southlake?
Custom and wood overlay doors here can weigh two to three times what a standard steel door weighs. A wood overlay or custom door puts two to three times the weight of a steel door on the same hardware. Heavier doors call for a wider and thicker gauge track with rollers carrying more ball bearings in the race. Cables are sized to the load as well, and a cable specified for a light steel door frays early where it wraps the drum.
Get it fixed
Get a cables and track price for your Southlake door
Tell us what it is doing. The estimate on site is free.