Jump to a service
Grapevine, TX
New garage door installation in Grapevine, Texas
A replacement door is a measuring job before it is a shopping decision. Opening width, headroom, backroom and the weight of the door chosen all decide what track and what spring the installation needs.
New doors in Grapevine
The older streets near Main Street have short driveways and limited headroom, while the newer north side has the depth an insulated sectional wants. A light pan door from the 1990s and a current insulated section are not the same load. Spring wire size, spring length, drum diameter and cable size all follow the finished weight of whatever door is hung, so the shaft assembly over the opening gets rebuilt to the new figures instead of carried across. Carriage house styling spread through 2000s construction, and doors in that style are almost always sectionals with overlay applied to the face rather than doors that swing. The overlay boards and the applied strap hardware add weight and stand proud of the section, so clearance to the stop molding and the spring calculation both account for the added material. A single door replacement is a half day, two doors a full day.
What that means for a Grapevine door
Openings framed in the 1960s sit in a two by four wall, and the jamb was often one board deep, enough for a thin one piece door and no more. A sectional wants jamb depth behind the stop molding for the track brackets and for roller travel, so those jambs are usually furred out with new stock before track goes on. A 16 foot opening is measured in more places than its width. Headroom is the gap between the top of the opening and the ceiling, and it sets whether standard torsion hardware clears or a low headroom conversion is needed. Backroom must take the open door plus the operator rail. Side room carries the vertical track on each jamb.
Signs you are dealing with this
- The garage is unbearably hot and the door has no insulation
- You are selling and the door is the first thing buyers see
What we check on arrival
- Opening width and height, squared and measured at multiple points
- Headroom, backroom and sideroom to confirm which track systems fit
$1100 to $4500
A standard insulated steel two-car door installed sits in the lower half. Custom sizes, wood or full-view glass doors run above the range.
This is a range, not a quote. The exact price comes after we see the door and you approve it before any work starts. Call (469) 281-7750 and describe what it is doing.
Grapevine at a glance
- County
- Tarrant County
- Drive from our Coppell base
- About 15 minutes from our Coppell base
- Postcodes covered
- 76051
- Around
- Historic Main Street, Grapevine Lake, Grapevine Mills
Before we get there
The old door still has loaded springs in it. Removal is the dangerous half of an installation, not the fitting.
About Grapevine
Older homes near Main Street sit on tight lots with short driveways, while the newer north side has deeper garages.
Tarrant County. About 15 minutes from our Coppell base.
What that means for a door here
The older streets near Main Street have short driveways and limited headroom, while the newer north side has the depth an insulated sectional wants.
We work throughout Grapevine, including the neighbourhoods around Historic Main Street, Grapevine Lake, Grapevine Mills.
Get a price
Tell us about your Grapevine door
Describe what the door is doing and somebody will call you back. The estimate on site is free. We are about 15 minutes away, and Grapevine sits in Tarrant County.
A person answers 7am to 11pm.
Questions
New doors in Grapevine, asked and answered
Do you cover Grapevine?
Yes. Grapevine is in Tarrant County, and it is one of the 32 cities covered from the Coppell base. About 15 minutes from our Coppell base. That covers postcode 76051.
What usually fails on a Grapevine door?
Attached garages built in the 1990s normally have drywall on the wall above the opening for fire separation from the house. Torsion hardware bolts through that layer into the header behind it, so the lag screws have to reach solid wood rather than stopping in gypsum. Finding the framing before the bearing plate is drilled matters more here than in a garage with open studs.
How long does new garage door installation take in Grapevine?
A single door replacement is a half day, two doors a full day. Factory finish on a steel door is a coil coating baked on before the panel is formed, which is why it wears differently from a brush applied paint. Repainting later means a clean, dull surface and a primer that grips a baked coating. Color choice also affects surface temperature, since a dark south facing door runs hotter than a pale one.
Is the work guaranteed?
Parts and labour carry a 5 year warranty. The price is agreed before any work starts, and the on site estimate is free.
Is there anything specific about garage doors in Grapevine?
Older homes near Main Street sit on tight lots with short driveways, while the newer north side has deeper garages. Steel thickness on a door is given as a gauge number, and a lower number means thicker steel. A single layer door has one skin doing all the structural work, so gauge is the main thing separating a light panel from one that resists a knock. Thin skins also drum more when the door runs, since there is no core damping the panel.
Get it fixed
Get a new doors price for your Grapevine door
Tell us what it is doing. The estimate on site is free.