Jump to a service
Garland, TX
New garage door installation in Garland, Texas
A replacement door is a measuring job before it is a shopping decision. Opening width, headroom, backroom and the weight of the door chosen all decide what track and what spring the installation needs.
New doors in Garland
An opener without photo eyes predates the 1993 federal requirement, and in Garland that is still a live category rather than a curiosity. Doors past about nine feet wide normally run a pair of torsion springs on a shaft that crosses the header, with a center bearing plate anchored to the wall between them. That plate is the anchor the springs wind against, so it has to land on solid framing. End bearing plates carry the shaft at each side and set where the cable drums sit. Residential track is usually 2 inch, and it comes in different steel gauges and in a 12 inch or 15 inch radius at the curve. The wider radius needs more headroom but eases the section through the turn. Track spacing off the jamb is set by the graduated brackets, and it decides how firmly the rollers hold the door against the stop molding. A single door replacement is a half day, two doors a full day.
What that means for a Garland door
Photo eyes have been required on residential garage door openers in the United States since 1993, so an opener older than that has no beam across the opening. A new door changes the weight the opener lifts, and an older unit sized for a light uninsulated door can struggle with an insulated replacement. Checking the opener at the same time avoids a mismatch. A wide section will bow across the middle under its own weight, which is why horizontal struts run the full width on the back of a 16 foot door. Strut count rises with door weight and with the width of the section. The top section carries one wherever an operator arm attaches, because that arm concentrates its pull on a single point.
Signs you are dealing with this
- Panels are dented, rusted through or delaminating
- The door is a one-piece tilt-up rather than a sectional
What we check on arrival
- Opening width and height, squared and measured at multiple points
- Headroom, backroom and sideroom to confirm which track systems fit
$1100 to $4500
A standard insulated steel two-car door installed sits in the lower half. Custom sizes, wood or full-view glass doors run above the range.
This is a range, not a quote. The exact price comes after we see the door and you approve it before any work starts. Call (469) 281-7750 and describe what it is doing.
Garland at a glance
- County
- Dallas County
- Drive from our Coppell base
- About 40 minutes from our Coppell base
- Postcodes covered
- 75040, 75041, 75042, 75043, 75044
- Around
- Downtown Garland Square, Lake Ray Hubbard, Firewheel Town Center
Before we get there
The old door still has loaded springs in it. Removal is the dangerous half of an installation, not the fitting.
About Garland
Openers old enough to lack photo eye sensors still turn up regularly in Garland.
Dallas County. About 40 minutes from our Coppell base.
What that means for a door here
An opener without photo eyes predates the 1993 federal requirement, and in Garland that is still a live category rather than a curiosity.
We work throughout Garland, including the neighbourhoods around Downtown Garland Square, Lake Ray Hubbard, Firewheel Town Center.
Get a price
Tell us about your Garland door
Describe what the door is doing and somebody will call you back. The estimate on site is free. We are about 40 minutes away, and Garland sits in Dallas County.
A person answers 7am to 11pm.
Questions
New doors in Garland, asked and answered
Do you cover Garland?
Yes. Garland is in Dallas County, and it is one of the 32 cities covered from the Coppell base. About 40 minutes from our Coppell base. That covers postcodes 75040, 75041, 75042, 75043, 75044.
What usually fails on a Garland door?
Garage slabs are poured with a slope toward the opening for drainage, and a 16 foot door sits across the whole of that slope. If the floor drops more on one side, a straight bottom section leaves a wedge of daylight at the low corner. A taller bulb seal absorbs some of it. Grinding or a threshold strip handles the rest.
How long does new garage door installation take in Garland?
A single door replacement is a half day, two doors a full day. Openings of the 1970s and 1980s were commonly closed with doors on extension springs stretched along the horizontal tracks and anchored at the rear hangers. Converting to torsion during installation puts a shaft and a spring anchor pad across the header. The lifting load then goes into the wall above the opening rather than back into the ceiling framing.
Is the work guaranteed?
Parts and labour carry a 5 year warranty. The price is agreed before any work starts, and the on site estimate is free.
Is there anything specific about garage doors in Garland?
Openers old enough to lack photo eye sensors still turn up regularly in Garland. Remotes from before the rolling code era send one fixed code set by dip switches inside the handset, and a receiver built now has nothing to learn from them. Handsets and keypads get replaced along with the head unit. Rolling code radios change the code they send at every press, which is why an old transmitter has nothing to pair to.
Get it fixed
Get a new doors price for your Garland door
Tell us what it is doing. The estimate on site is free.