Jump to a service
Flower Mound, TX
Garage door spring replacement in Flower Mound, Texas
A broken torsion spring is the most common reason a door stops lifting. The fix is a matched pair sized to what the door actually weighs, not the cheapest spring that fits the shaft.
A torsion spring stores enough energy to cause serious injury. It should only be unwound, adjusted or replaced with proper winding bars by someone trained to use them. This is not a do it yourself repair at any skill level.
Springs in Flower Mound
A three bay elevation in Flower Mound usually carries two different spring specifications, because the wide door and the two standard doors are not balancing the same weight. Some doors of that period carry an enclosed counterbalance, with the torsion spring running inside a steel tube above the opening and wound through a fitting at one end rather than with bars. A spring that fails inside the tube leaves nothing visible from the floor. The first sign is a door the opener can no longer lift. Doors of that period are commonly seven feet tall, built from four sections of about twenty one inches. Winding follows door height rather than width: on standard drums a seven foot door takes roughly seven and a half turns, and an eight foot door about a turn more. Turns set the balance, so a correctly sized spring wound short still leaves the door out of balance. Usually under two hours from arrival.
What that means for a Flower Mound door
Steel loses a little toughness as it gets cold and the grease on the coils thickens, so a spring already near the end of its cycle life often lets go on the first hard freeze of the season rather than on a mild afternoon. The cold does not wear the spring out. It finishes off one that was already close. The red release cord drops the door off the opener trolley so it can be worked by hand. With a broken spring, that hand is holding the whole door, and a double door in that state is beyond what one person should lift. A door already up when the spring fails should be left up and blocked rather than pulled down.
Signs you are dealing with this
- A visible gap in the coil of the spring above the door
- The door is far too heavy to lift by hand
What we check on arrival
- Door balance after installation, tested by hand at three heights
- Spring wire size, inside diameter and length to confirm correct sizing
$200 to $450
A standard pair of torsion springs on a two-car door sits mid-range. Oversized, high-cycle or custom-weight doors run higher.
This is a range, not a quote. The exact price comes after we see the door and you approve it before any work starts. Call (469) 281-7750 and describe what it is doing.
Flower Mound at a glance
- County
- Denton County
- Drive from our Coppell base
- About 20 minutes from our Coppell base
- Postcodes covered
- 75022, 75028
- Around
- The Flower Mound, Grapevine Lake shoreline, Parker Square
Before we get there
A torsion spring stores enough energy to cause serious injury. It should only be unwound, adjusted or replaced with proper winding bars by someone trained to use them. This is not a do it yourself repair at any skill level.
About Flower Mound
Three bay garages here frequently pair two standard doors with one wider door.
Denton County. About 20 minutes from our Coppell base.
What that means for a door here
A three bay elevation in Flower Mound usually carries two different spring specifications, because the wide door and the two standard doors are not balancing the same weight.
We work throughout Flower Mound, including the neighbourhoods around The Flower Mound, Grapevine Lake shoreline, Parker Square.
Get a price
Tell us about your Flower Mound door
If the door is stuck open or will not close, call. That is a security problem and the phone is faster than anything else on this page. We are about 20 minutes away, and Flower Mound sits in Denton County.
A person answers 7am to 11pm.
Questions
Springs in Flower Mound, asked and answered
Do you cover Flower Mound?
Yes. Flower Mound is in Denton County, and it is one of the 32 cities covered from the Coppell base. About 20 minutes from our Coppell base. That covers postcodes 75022, 75028.
What usually fails on a Flower Mound door?
Winding cones take steel winding bars sized to the holes in the cone, and anything else, including screwdrivers and rebar, slips out under load. The set screws bite into the shaft itself, so a shaft already dimpled from earlier work gives them less to hold. Chalk drawn along a wound shaft shows at a glance whether a cone has since slipped.
How long does garage door spring replacement take in Flower Mound?
Usually under two hours from arrival. A three bay elevation with two singles and a double needs more than one spring specification. The double is roughly twice the weight of each single, so the shafts carry different springs even though the doors were installed together and look alike from the street. Replacing all three with the same part leaves two of them out of balance.
Is the work guaranteed?
Parts and labour carry a 5 year warranty. The price is agreed before any work starts, and the on site estimate is free.
Is there anything specific about garage doors in Flower Mound?
Three bay garages here frequently pair two standard doors with one wider door. Original paperwork rarely survives on a door hung in the 1990s or 2000s, so the replacement spring is specified from the broken one. Wire diameter is found by pushing twenty coils together, measuring that length and dividing by twenty. Inside diameter is often stamped on the cone. Length is measured with the spring at rest, and the wind direction is read off the coil.
Get it fixed
Get a springs price for your Flower Mound door
Tell us what it is doing. The estimate on site is free.