Jump to a service
Coppell, TX
Garage door spring replacement in Coppell, Texas
A broken torsion spring is the most common reason a door stops lifting. The fix is a matched pair sized to what the door actually weighs, not the cheapest spring that fits the shaft.
A torsion spring stores enough energy to cause serious injury. It should only be unwound, adjusted or replaced with proper winding bars by someone trained to use them. This is not a do it yourself repair at any skill level.
Springs in Coppell
Coppell's large subdivisions went up within a few years of each other, so whole streets reach the end of their original spring life at roughly the same time. Some doors of that period carry an enclosed counterbalance, with the torsion spring running inside a steel tube above the opening and wound through a fitting at one end rather than with bars. A spring that fails inside the tube leaves nothing visible from the floor. The first sign is a door the opener can no longer lift. Torsion springs are handed. A left wound spring and a right wound spring are not interchangeable, and the winding cones are commonly colored to show which is which, red for left wound and black for right wound. On a two spring shaft one of each is fitted, mounted either side of the center bracket, so a matched pair means matched in hand as well as in size. Usually under two hours from arrival.
What that means for a Coppell door
Spring life is counted in cycles rather than years, where one cycle is a full open and close. A house that uses the garage as its main entrance can run eight cycles a day, which works through a 10,000 cycle spring in three to four years. The same spring on a door opened twice a day lasts well over a decade. With the trolley released from the opener, a correctly balanced door can be raised by hand with steady effort and will hold position around halfway without being held. A door that sinks or climbs on its own is out of balance, and no adjustment at the opener corrects it. The test only means anything with the opener disconnected.
Signs you are dealing with this
- The door slams down rather than lowering under control
- A loud bang from the garage, then the door will not open
What we check on arrival
- Center bearing plate and end bearing wear
- Door balance after installation, tested by hand at three heights
$200 to $450
A standard pair of torsion springs on a two-car door sits mid-range. Oversized, high-cycle or custom-weight doors run higher.
This is a range, not a quote. The exact price comes after we see the door and you approve it before any work starts. Call (469) 281-7750 and describe what it is doing.
Coppell at a glance
- County
- Dallas County
- Drive from our Coppell base
- We are based here
- Postcodes covered
- 75019
- Around
- Old Town Coppell, Andrew Brown Park, Coppell Town Center
Before we get there
A torsion spring stores enough energy to cause serious injury. It should only be unwound, adjusted or replaced with proper winding bars by someone trained to use them. This is not a do it yourself repair at any skill level.
About Coppell
Most Coppell garages hold a builder-grade steel door fitted between 1992 and 2005, which puts the original torsion springs well past their rated cycle count.
Dallas County. We are based here.
What that means for a door here
Coppell's large subdivisions went up within a few years of each other, so whole streets reach the end of their original spring life at roughly the same time.
We work throughout Coppell, including the neighbourhoods around Old Town Coppell, Andrew Brown Park, Coppell Town Center.
Get a price
Tell us about your Coppell door
If the door is stuck open or will not close, call. That is a security problem and the phone is faster than anything else on this page. We are based here, and Coppell sits in Dallas County.
A person answers 7am to 11pm.
Questions
Springs in Coppell, asked and answered
Do you cover Coppell?
Yes. Coppell is in Dallas County, and it is one of the 32 cities covered from the Coppell base. We are based here. That covers postcode 75019.
What usually fails on a Coppell door?
Steel loses a little toughness as it gets cold and the grease on the coils thickens, so a spring already near the end of its cycle life often lets go on the first hard freeze of the season rather than on a mild afternoon. The cold does not wear the spring out. It finishes off one that was already close.
How long does garage door spring replacement take in Coppell?
Usually under two hours from arrival. Anything added to a door changes what the springs have to balance. An insulation kit bonded to the inside of single layer panels adds weight the original spring was not wound for, and so does a replacement section with glass in it. The door usually still opens, but the balance point moves and the opener works harder on every cycle.
Is the work guaranteed?
Parts and labour carry a 5 year warranty. The price is agreed before any work starts, and the on site estimate is free.
Is there anything specific about garage doors in Coppell?
Most Coppell garages hold a builder-grade steel door fitted between 1992 and 2005, which puts the original torsion springs well past their rated cycle count. A broken torsion spring shows as a gap of an inch or two in the coil, usually visible from the floor by looking at the shaft above the door. The break often announces itself as a single loud bang from an empty garage. After it, the opener may hum and move the trolley while the door stays on the floor.
Get it fixed
Get a springs price for your Coppell door
Tell us what it is doing. The estimate on site is free.