Jump to a service
Denton, TX
Garage door spring replacement in Denton, Texas
A broken torsion spring is the most common reason a door stops lifting. The fix is a matched pair sized to what the door actually weighs, not the cheapest spring that fits the shaft.
A torsion spring stores enough energy to cause serious injury. It should only be unwound, adjusted or replaced with proper winding bars by someone trained to use them. This is not a do it yourself repair at any skill level.
Springs in Denton
A door opening eight times a day gets through a 10,000 cycle spring in around three and a half years, which is why rental stock near the universities wears differently. Steel got thinner as the decades passed. A single layer door pressed in the 1970s uses a heavier gauge than a current builder panel of the same size, and it weighs accordingly. Sizing a spring from a chart keyed to door width and height can therefore come out light on an older door. Two doors of identical size from different decades are not the same load. Doors serving rentals and small commercial buildings run more cycles per year than an owner occupied single family garage. Spring wear tracks cycle count, so the same part fails sooner under that pattern. A high cycle spring uses heavier wire on a larger inside diameter to carry the same door weight for more openings before fatigue sets in. Usually under two hours from arrival.
What that means for a Denton door
Anything added to a door changes what the springs have to balance. An insulation kit bonded to the inside of single layer panels adds weight the original spring was not wound for, and so does a replacement section with glass in it. The door usually still opens, but the balance point moves and the opener works harder on every cycle. A wood door that is still original has not weighed the same all its life. Timber takes on moisture in a damp garage and gives it back in dry months, and layers of paint add to the section over the years. The spring was wound for the door as it left the shop. The same door can sit differently in a wet season than in a dry one.
Signs you are dealing with this
- A visible gap in the coil of the spring above the door
- The door is far too heavy to lift by hand
What we check on arrival
- Spring wire size, inside diameter and length to confirm correct sizing
- Whether the existing springs were correctly specified for the door weight
$200 to $450
A standard pair of torsion springs on a two-car door sits mid-range. Oversized, high-cycle or custom-weight doors run higher.
This is a range, not a quote. The exact price comes after we see the door and you approve it before any work starts. Call (469) 281-7750 and describe what it is doing.
Denton at a glance
- County
- Denton County
- Drive from our Coppell base
- About 40 minutes from our Coppell base
- Postcodes covered
- 76201, 76205, 76207, 76208, 76209, 76210
- Around
- Denton County Courthouse on the Square, University of North Texas, Ray Roberts Lake
Before we get there
A torsion spring stores enough energy to cause serious injury. It should only be unwound, adjusted or replaced with proper winding bars by someone trained to use them. This is not a do it yourself repair at any skill level.
About Denton
Rental properties near the two universities cycle tenants often, and garage doors get used harder than average as a result.
Denton County. About 40 minutes from our Coppell base.
What that means for a door here
A door opening eight times a day gets through a 10,000 cycle spring in around three and a half years, which is why rental stock near the universities wears differently.
We work throughout Denton, including the neighbourhoods around Denton County Courthouse on the Square, University of North Texas, Ray Roberts Lake.
Get a price
Tell us about your Denton door
If the door is stuck open or will not close, call. That is a security problem and the phone is faster than anything else on this page. We are about 40 minutes away, and Denton sits in Denton County.
A person answers 7am to 11pm.
Questions
Springs in Denton, asked and answered
Do you cover Denton?
Yes. Denton is in Denton County, and it is one of the 32 cities covered from the Coppell base. About 40 minutes from our Coppell base. That covers postcodes 76201, 76205, 76207, 76208, 76209, 76210.
What usually fails on a Denton door?
A garage door opener is sized to move a balanced door, not to lift a dead weight. Openers are typically half to three quarter horsepower, which is enough only while the springs carry the door. When a spring weakens, the opener strains, and on older units without modern force sensing it keeps pulling until something in the drive gives out.
How long does garage door spring replacement take in Denton?
Usually under two hours from arrival. A 16 foot double door weighs roughly 150 to 250 pounds depending on panel construction, and the torsion assembly above the header carries all of it. Most double doors of this width run a pair of springs on a shared shaft. When one breaks the other is usually near the end of its life, since both were wound the same day and cycled the same number of times.
Is the work guaranteed?
Parts and labour carry a 5 year warranty. The price is agreed before any work starts, and the on site estimate is free.
Is there anything specific about garage doors in Denton?
Rental properties near the two universities cycle tenants often, and garage doors get used harder than average as a result. Single layer steel doors sit at the light end of the residential weight range, so their springs store less energy than an insulated door of the same width. The correct replacement is still read off the old spring: wire diameter, inside diameter, length, and wind direction. Door width alone does not determine the spring, because panel construction changes the weight it has to balance.
Get it fixed
Get a springs price for your Denton door
Tell us what it is doing. The estimate on site is free.