Jump to a service
Denton, TX
New garage door installation in Denton, Texas
A replacement door is a measuring job before it is a shopping decision. Opening width, headroom, backroom and the weight of the door chosen all decide what track and what spring the installation needs.
New doors in Denton
A door opening eight times a day gets through a 10,000 cycle spring in around three and a half years, which is why rental stock near the universities wears differently. A wall control belongs at least 5 feet above the floor so the door cannot be run by a small child standing under it. Buttons put in during the 1980s sit at light switch height beside the entry door more often than not. Fresh low voltage wire is run up to the higher position rather than spliced onto the old pair. Carriage house styling spread through 2000s construction, and doors in that style are almost always sectionals with overlay applied to the face rather than doors that swing. The overlay boards and the applied strap hardware add weight and stand proud of the section, so clearance to the stop molding and the spring calculation both account for the added material. A single door replacement is a half day, two doors a full day.
What that means for a Denton door
Vertical track on a 16 foot opening bolts to the jamb, so the jamb has to be sound wood fastened to the framing rather than trim tacked over masonry. Rot at the base is common where the jamb meets the slab. A jamb that is out of plumb pulls the track with it, and the door then binds on one side as it travels. A 16 foot opening is measured in more places than its width. Headroom is the gap between the top of the opening and the ceiling, and it sets whether standard torsion hardware clears or a low headroom conversion is needed. Backroom must take the open door plus the operator rail. Side room carries the vertical track on each jamb.
Signs you are dealing with this
- Panels are dented, rusted through or delaminating
- The door is a one-piece tilt-up rather than a sectional
What we check on arrival
- Header, jamb and framing condition behind the existing door
- Whether the existing opener suits the weight of the new door
$1100 to $4500
A standard insulated steel two-car door installed sits in the lower half. Custom sizes, wood or full-view glass doors run above the range.
This is a range, not a quote. The exact price comes after we see the door and you approve it before any work starts. Call (469) 281-7750 and describe what it is doing.
Denton at a glance
- County
- Denton County
- Drive from our Coppell base
- About 40 minutes from our Coppell base
- Postcodes covered
- 76201, 76205, 76207, 76208, 76209, 76210
- Around
- Denton County Courthouse on the Square, University of North Texas, Ray Roberts Lake
Before we get there
The old door still has loaded springs in it. Removal is the dangerous half of an installation, not the fitting.
About Denton
Rental properties near the two universities cycle tenants often, and garage doors get used harder than average as a result.
Denton County. About 40 minutes from our Coppell base.
What that means for a door here
A door opening eight times a day gets through a 10,000 cycle spring in around three and a half years, which is why rental stock near the universities wears differently.
We work throughout Denton, including the neighbourhoods around Denton County Courthouse on the Square, University of North Texas, Ray Roberts Lake.
Get a price
Tell us about your Denton door
Describe what the door is doing and somebody will call you back. The estimate on site is free. We are about 40 minutes away, and Denton sits in Denton County.
A person answers 7am to 11pm.
Questions
New doors in Denton, asked and answered
Do you cover Denton?
Yes. Denton is in Denton County, and it is one of the 32 cities covered from the Coppell base. About 40 minutes from our Coppell base. That covers postcodes 76201, 76205, 76207, 76208, 76209, 76210.
What usually fails on a Denton door?
Doors ordered in volume for subdivisions through the 1990s and 2000s came with builder grade hardware, usually short stem steel rollers turning in light gauge track. The rough opening sets none of that. Longer stem rollers with sealed bearings and nylon tires fit the same jambs, and track gauge and hinge stock are specified apart from the panel design.
How long does new garage door installation take in Denton?
A single door replacement is a half day, two doors a full day. Steel thickness on a door is given as a gauge number, and a lower number means thicker steel. A single layer door has one skin doing all the structural work, so gauge is the main thing separating a light panel from one that resists a knock. Thin skins also drum more when the door runs, since there is no core damping the panel.
Is the work guaranteed?
Parts and labour carry a 5 year warranty. The price is agreed before any work starts, and the on site estimate is free.
Is there anything specific about garage doors in Denton?
Rental properties near the two universities cycle tenants often, and garage doors get used harder than average as a result. Operator type is decided at installation, not after. A trolley unit runs on a rail down the center of the ceiling and needs backroom for that rail. A jackshaft unit mounts on the wall beside the torsion shaft and drives it directly, which frees the ceiling but requires a shaft and bearing arrangement suited to side mounting.
Get it fixed
Get a new doors price for your Denton door
Tell us what it is doing. The estimate on site is free.