Jump to a service
Highland Village, TX
Garage door cable and track repair in Highland Village, Texas
A door hanging crooked, off its rail, or with a cable coiled at the bottom bracket is carrying its load somewhere it was not designed to. That is not a door to keep operating.
A door off its track can fall. Do not run the opener to try to correct it, and keep people and vehicles out from under it until it is secured.
Cables and track in Highland Village
Larger doors and open lake exposure find a weak track bracket faster than either would on its own. Two ways of hanging vertical track are common on doors of that era. Stamped jamb brackets bolt through slots in the track, which allows adjustment and also allows drift once the bolts loosen. A continuous steel angle running the height of the opening holds the track in one plane instead. Doors that come out of alignment repeatedly are often on the bracket method with worn slots. Cable drums are cast or extruded aluminum with a spiral groove that the cable follows. Years of load cut a lip into that groove, and the worn edge cuts into a new cable instead of cradling it. A drum that has run with a slack cable often has a flat spot at the top of the spiral where the wrap jumped its lane. Most track and cable work is one to two hours.
What that means for a Highland Village door
Lift cables are galvanized aircraft cable, and the diameter is chosen for the weight hanging on it. Wear shows first as broken strands, usually at the loop over the bottom bracket pin or at the first wrap on the drum. A cable with one strand gone is on its way out, and the pair is replaced together because both have run the same cycles. Residential vertical track from this period is commonly graduated rather than parallel to the jamb, with a slight taper along its length so the sections tighten against the weather seal as the door comes down. A track hung dead parallel leaves the door standing off the stop at one end of its travel. The taper is by design rather than a bend in the steel.
Signs you are dealing with this
- Rollers are jumping out of the rail at the curve
- The rail has a visible bend or a gap at a joint
What we check on arrival
- Both lift cables end to end, including where they wrap the drums
- Vertical and horizontal track for bends, spread and loose fasteners
$150 to $450
Resetting a door on its track with new rollers is at the low end. Replacing cables, drums and a bent rail section is at the high end.
This is a range, not a quote. The exact price comes after we see the door and you approve it before any work starts. Call (469) 281-7750 and describe what it is doing.
Highland Village at a glance
- County
- Denton County
- Drive from our Coppell base
- About 25 minutes from our Coppell base
- Postcodes covered
- 75077
- Around
- Lewisville Lake, Unity Park, Doubletree Ranch Park
Before we get there
A door off its track can fall. Do not run the opener to try to correct it, and keep people and vehicles out from under it until it is secured.
About Highland Village
Larger doors and open lake exposure is a combination that finds weak track brackets.
Denton County. About 25 minutes from our Coppell base.
What that means for a door here
Larger doors and open lake exposure find a weak track bracket faster than either would on its own.
We work throughout Highland Village, including the neighbourhoods around Lewisville Lake, Unity Park, Doubletree Ranch Park.
Get a price
Tell us about your Highland Village door
If the door is stuck open or will not close, call. That is a security problem and the phone is faster than anything else on this page. We are about 25 minutes away, and Highland Village sits in Denton County.
A person answers 7am to 11pm.
Questions
Cables and track in Highland Village, asked and answered
Do you cover Highland Village?
Yes. Highland Village is in Denton County, and it is one of the 32 cities covered from the Coppell base. About 25 minutes from our Coppell base. That covers postcode 75077.
What usually fails on a Highland Village door?
Sectional door hinges are stamped with a number that says where they belong, 1 at the joint nearest the bottom and rising with each joint above it. The number sets how far the roller stem stands off the panel. A hinge fitted in the wrong position pushes that section toward or away from the track and loads one roller against the track lip.
How long does garage door cable and track repair take in Highland Village?
Most track and cable work is one to two hours. Track and brackets from this period are punched to a manufacturer's own pattern, and the patterns are not shared. A horizontal section of track from one maker bolted to a curve from another leaves the joint a fraction out, which the rollers find on every pass. Matching the existing hardware matters more than matching the nominal size printed on it.
Is the work guaranteed?
Parts and labour carry a 5 year warranty. The price is agreed before any work starts, and the on site estimate is free.
Is there anything specific about garage doors in Highland Village?
Larger doors and open lake exposure is a combination that finds weak track brackets. Horizontal track is hung with a slight downward pitch toward the back of the garage so the door settles against the weatherstrip at the header when it closes. The rear hangers carry that geometry and have to land in framing, not in drywall. Track that sags between hangers shows as a door that hesitates at the curve on the way down.
Get it fixed
Get a cables and track price for your Highland Village door
Tell us what it is doing. The estimate on site is free.