Jump to a service
Carrollton, TX
Garage door spring replacement in Carrollton, Texas
A broken torsion spring is the most common reason a door stops lifting. The fix is a matched pair sized to what the door actually weighs, not the cheapest spring that fits the shaft.
A torsion spring stores enough energy to cause serious injury. It should only be unwound, adjusted or replaced with proper winding bars by someone trained to use them. This is not a do it yourself repair at any skill level.
Springs in Carrollton
The alley garages near the Carrollton square are shallow enough that a standard track radius will not fit, which is what makes a low headroom conversion common here. Doors of that period are commonly seven feet tall, built from four sections of about twenty one inches. Winding follows door height rather than width: on standard drums a seven foot door takes roughly seven and a half turns, and an eight foot door about a turn more. Turns set the balance, so a correctly sized spring wound short still leaves the door out of balance. An insulated steel door carries polystyrene or polyurethane between two skins, which adds weight over a single layer panel of identical width. Springs have to be wound for that extra load. Fitting a spring specified for a lighter door leaves the door heavy at the floor and drifting closed from waist height, and it shortens the opener's working life. Usually under two hours from arrival.
What that means for a Carrollton door
Garages built in the 1950s and 1960s were commonly fitted with extension springs running along the horizontal tracks, one on each side, rather than a torsion shaft over the opening. Extension springs stretch and relax with every cycle and rely on pulleys and a cable for balance. Many of those doors have since been converted to torsion, so the original hardware is not a given. Torsion springs are handed. A left wound spring and a right wound spring are not interchangeable, and the winding cones are commonly colored to show which is which, red for left wound and black for right wound. On a two spring shaft one of each is fitted, mounted either side of the center bracket, so a matched pair means matched in hand as well as in size.
Signs you are dealing with this
- The door slams down rather than lowering under control
- A loud bang from the garage, then the door will not open
What we check on arrival
- Door balance after installation, tested by hand at three heights
- Spring wire size, inside diameter and length to confirm correct sizing
$200 to $450
A standard pair of torsion springs on a two-car door sits mid-range. Oversized, high-cycle or custom-weight doors run higher.
This is a range, not a quote. The exact price comes after we see the door and you approve it before any work starts. Call (469) 281-7750 and describe what it is doing.
Carrollton at a glance
- County
- Dallas County
- Drive from our Coppell base
- About 15 minutes from our Coppell base
- Postcodes covered
- 75006, 75007, 75010
- Around
- Downtown Carrollton Square, A.W. Perry Homestead Museum, Josey Ranch Lake
Before we get there
A torsion spring stores enough energy to cause serious injury. It should only be unwound, adjusted or replaced with proper winding bars by someone trained to use them. This is not a do it yourself repair at any skill level.
About Carrollton
The alley access garages near the square are often shallow, which rules out some standard track configurations.
Dallas County. About 15 minutes from our Coppell base.
What that means for a door here
The alley garages near the Carrollton square are shallow enough that a standard track radius will not fit, which is what makes a low headroom conversion common here.
We work throughout Carrollton, including the neighbourhoods around Downtown Carrollton Square, A.W. Perry Homestead Museum, Josey Ranch Lake.
Get a price
Tell us about your Carrollton door
If the door is stuck open or will not close, call. That is a security problem and the phone is faster than anything else on this page. We are about 15 minutes away, and Carrollton sits in Dallas County.
A person answers 7am to 11pm.
Questions
Springs in Carrollton, asked and answered
Do you cover Carrollton?
Yes. Carrollton is in Dallas County, and it is one of the 32 cities covered from the Coppell base. About 15 minutes from our Coppell base. That covers postcodes 75006, 75007, 75010.
What usually fails on a Carrollton door?
Extension springs on doors from the 1970s and 1980s should carry a containment cable threaded through the center of the spring. Without it, a spring that fails under tension can travel across the garage. Retrofit containment cables fit older assemblies. Torsion conversions became more common on doors built after this period, which is why hardware varies house to house in the same tract.
How long does garage door spring replacement take in Carrollton?
Usually under two hours from arrival. Opener force settings are adjusted to a door as it was balanced on the day of the setting. Replace a spring and the effort curve changes, so limits and force should be checked again afterward. A door that reverses partway down or stops short of the floor is often running settings left over from a tired spring rather than reporting a track fault.
Is the work guaranteed?
Parts and labour carry a 5 year warranty. The price is agreed before any work starts, and the on site estimate is free.
Is there anything specific about garage doors in Carrollton?
The alley access garages near the square are often shallow, which rules out some standard track configurations. The stationary cones of a torsion assembly bolt to a spring anchor bracket fastened into the header above the opening. On a 16 foot door that bracket resists the torque of both springs. Lag screws pulling out of a split or shimmed header let the bracket shift, which shows up as the shaft climbing away from the wall when the door is closed.
Get it fixed
Get a springs price for your Carrollton door
Tell us what it is doing. The estimate on site is free.